Date: 16-06-24  Time: 06:51 am

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rsvphil

Pages: [1]
1
FZS600 Fazer / Re: fzs 600 carburettors
« on: 20 March 2016, 09:39:37 am »
Definitely not Sidestand switch the bike is on a table. The bike only starts snd runs when I strip and rebuild the carbs. But once left for a while she won't fire again until carbs are removed rebuilt and refitted.

2
FZS600 Fazer / Re: fzs 600 carburettors
« on: 29 February 2016, 10:21:00 pm »
Little update guys. Stripped the carbs out again and reset all the pilot screws. Reassembled and bike fired straight up. Wasn't running properly hunting quite a lot with a delay on the throttle. Basically slow to respond to input of the throttle also seemed to stick a bit before the revs dropped. After letting it run for a good ten minutes switched it off and left it for 20 mins. Came back out and it started up straight away. Left for 2 hours wouldn't start and now back to square one doesn't fire at all.

3
FZS600 Fazer / Re: fzs 600 carburettors
« on: 24 January 2016, 11:43:59 pm »
Pump seems to be working fine and the carbs seem to have fuel in the float bowls.

4
FZS600 Fazer / Re: fzs 600 carburettors
« on: 24 January 2016, 11:12:40 pm »
I removed the carbs again and checked everything over snd all seemed good. Reassembled and got the bike running a dusted the the idle and was satisfied I'd cured the problem. However after I came back to the bike a couple of hours later it wouldn't fire and hsnt fired once since.

5
FZS600 Fazer / Re: fzs 600 carburettors
« on: 24 January 2016, 07:58:30 am »
Is there a cure for the carb slides sticking open? How did you fix your issue?

6
FZS600 Fazer / Re: fzs 600 carburettors
« on: 08 January 2016, 09:49:00 pm »
Tried turning the fuel tap off and still nothing.

7
FZS600 Fazer / Re: fzs 600 carburettors
« on: 06 January 2016, 11:57:15 pm »
Tried with choke without choke. Nothing won't fire at all.

8
FZS600 Fazer / Re: fzs 600 carburettors
« on: 06 January 2016, 10:16:13 pm »
Hi all sorry for the delay had some unexpected health issues since my last post. Fingers crossed I can get this bloody bike going now. Just been out this evening and turned the bike over. The fuel pump primed straight away But made no attempt to fire. Checked all spark plugs and getting good spark. At a complete loss.

9
FZS600 Fazer / Re: fzs 600 carburettors
« on: 27 November 2015, 10:15:49 am »
Everything is set as it should be according to manual. As it was before I fettled with it.

10
FZS600 Fazer / Re: fzs 600 carburettors
« on: 17 November 2015, 08:47:56 pm »
Right had the carbs out again and took the top covers off and removed the diaphragms and needles then removed the float chamber bowls and made sure the jets were all clear. Checked over everything I could see and rebuilt them and fitted them back on the bike. Managed to get it running and without the choke so was mightily relieved. However later on went back out started for a second then died and won't fire. So back to square one.

11
FZS600 Fazer / Re: fzs 600 carburettors
« on: 14 November 2015, 11:22:22 pm »
So far I've checked that there's fuel going through the filter into the pump. The pump is working as it should. And the float chambers are full I just really don't understand it.

12
FZS600 Fazer / Re: fzs 600 carburettors
« on: 14 November 2015, 03:22:58 pm »
Yep all clear. But surely that wouldn't explain why it will run for 2 seconds when it's been left for half hour then not run at all? It's baffling me. I think the carbs are gonna have to come back out

13
FZS600 Fazer / Re: fzs 600 carburettors
« on: 14 November 2015, 01:44:16 pm »
Fuel filter replaced and air filter checked.

14
FZS600 Fazer / Re: fzs 600 carburettors
« on: 14 November 2015, 12:36:50 pm »
It ran on the choke before the carbs came out now the choke doesn't have any effect. If you leave it for a period of time it will fire straight away and rev to about 6000rpm for two seconds then dies then won't fire again unless you leave it for half hour. Whilst it does run twist the throttle has no effect. Checked over everything again and again and can't see anything out of place or damaged.

15
FZS600 Fazer / fzs 600 carburettors
« on: 13 November 2015, 02:08:11 pm »
Hey everyone got a problem with my brothers bike. He asked me to do some work, fork seals, chain sprockets etc but then decided to tell me it wasn't running properly. It would only run on the choke and wouldn't tick over, as soon as you touched the throttle it would cut out. I drained the carbs and removed them and gave them a quick clean made sure the jets were all clear. Refitted them and couldn't get it running. After leaving it overnight it fired straight up and revved really high for 2 seconds then wouldn't fire again. If you leave it for a period of time it will start or attempt to start for a couple of seconds then nothing. It does turn over and spark fine it's just not getting fuel.  The float chambers are full of fuel. Any help much appreciated .

16
Fazer 1000/FZ1 corner / Re: fazer 1000 gen 1 pillion grab rails
« on: 03 April 2012, 10:06:03 pm »
Gotcha, yeah seen those but their both right hand side. :'(

17
Fazer 1000/FZ1 corner / Re: fazer 1000 gen 1 pillion grab rails
« on: 03 April 2012, 08:00:54 pm »
I hate to sound backward but what's fblog?

18
Fazer 1000/FZ1 corner / fazer 1000 gen 1 pillion grab rails
« on: 03 April 2012, 06:20:23 pm »
Hi everyone. When I bought my fazer 4 years ago it came with no grab rails, I bought a pair straight away off eBay, I sold the bike two years ago and a few weeks ago I came across it for sale and decided to buy her back. Guess what no grab rails again. This time I can't find any. Does anyone have any that they would like to sell?

Pages: [1]