Date: 15-06-24  Time: 22:46 pm

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - davey boy

Pages: 1 2 3 [4]
76
Fazer 1000/FZ1 corner / Re: power comander
« on: 14 March 2015, 11:03:39 am »
I have ordered a pcv that comes with a o2 sensor eliminator just wondering where does it plug in and do you have to remove it to upload new maps

77
General / Re: Throw over Panniers
« on: 14 March 2015, 08:10:33 am »
I bought a second hand set of Oxford ones and the seller included a sheet of the grip mat stuff just cut the middle out to suit your bike and then it holds itself in place without the gaffs tape leaving sticky mess behind

78
General / Re: Intercoms and the like
« on: 14 March 2015, 08:06:31 am »
I use the Senna bike to bike and for music and the like
You push the big jog dial button on the side to open the intercom and then again to close it down they are good up to half a mile with line of sight but less if things get in the way
The only problem I have is the noise from my screen on the fz1 above about 50 it was ok on other bikes

79
Fazer 1000/FZ1 corner / Re: Power commander 3 VS 5
« on: 11 March 2015, 09:51:01 am »
Just looked on the dynojet website and it says a PCV part no 22-015 will fit my 07 bike but on ebay listings with the same part no says 09 - 11
Anyone taken the chance before they are about £100 cheaper

80
Fazer 1000/FZ1 corner / Re: power comander
« on: 11 March 2015, 09:29:58 am »
Thanks for the replies think I am going to go for a PCV if I can get one at a reasonable price do I need an oxygen sensor or anything else with it

81
Done the north west coast of scotland year before last the pass of the cattle to applecross was amazing and the road up to durness was so quiet with only packs of bmw tourers to be seen
Off to the outer hebridees this year ferry from oban and back via sky cant wait
Going for a record of ferries on a trip six at the last count

82
Fazer 1000/FZ1 corner / Re: Wiring in a Satnav.
« on: 10 March 2015, 07:55:11 pm »
Inline fuze holder, an automotive relay a bit of wire all for under a fiver

83
General / Re: What bikes do you have in your garage?
« on: 10 March 2015, 06:57:11 pm »
07 fz1
05 ktm 450 exc to get dirty on
Yamaha tyz 250 trials bike for kicks

84
Fazer 1000/FZ1 corner / power comander
« on: 09 March 2015, 09:24:39 pm »
Hi just joined got a 2007 fz1 done a few mods mostly cosmetic but have put on a scorpian slipon can, bmc airfilter and the fce chickened out of cutting the airbox
Do i need a power comander or will the engine run ok and if i do get one is there a map to suit my bike set up or will i have to get it on a dyno
Ps any rideouts up north i live on the west coast of cumbria
Thanks in advance Dave

85
Fazer 1000/FZ1 corner / Re: Wiring in a Satnav.
« on: 08 March 2015, 05:19:22 pm »
I bought an automotive relay from ebay and you basically wire it through the relay to the battery and earth the relay then splice a wire into a switched circuit (i used the numberplate light) and connect this to the relay there are 3 or 4 tabs on a relay depending on the one you buy here is alink that might help http://www.mp3car.com/the-faq-emporium/117895-faq-relays-how-they-work-and-how-to-wire-it-up.html

86
Introduction / new guy cumbria
« on: 08 March 2015, 04:56:16 pm »
Hi all just found this forum when i was looking for help instaling a fce great thread made it a doddle :-) to my 07 fz1 1000 great bike
Just took her out for a shakedown and the snatch is gone great
Went over hardknot pass and down the duddon valley so fortunate to have this on my dorstep
Anyone elce in the west of the county?
Dave

87
Fazer 1000/FZ1 corner / Re: Wiring in a Satnav.
« on: 04 March 2015, 10:15:15 pm »
You can wire an automotive relay in and mount it on the rear sub frame in the seat shroud just wire the switced terminal to the licence plate light

Pages: 1 2 3 [4]