Hi guys, first post here. I've had a search but I can't find the cure for my clutch slip.


When I bough the bike it slipped a bit. Adjusting the cable didn't help much but adjusting the rod on the other end of the engine did. But it would occasionally still slip at high rpm in the higher gears.


I bit the bullet and ordered new springs, friction plates and gasket. Fitted earlier on and it all went to plan until I came to adjust the clutch. I tightened the bottom adjuster then slackened it quarter turn as per the instructions. Then adjusting the lever needed almost all of my adjustment to get it right with a few mm of play. But pulling away it's slipping really bad to the point I could probably keep it in first and hold it still with the clutch released.


I've tried adjusting the bottom adjuster tighter and looser but still can't get it right.


Anyone have any ideas?


Thanks, Carl