1
Fazer 1000/FZ1 corner / Re: ?? two connectors with the bridging wire ??
« on: 06 November 2012, 08:51:12 pm »I always wondered what they were but was afraid to ask?Me too but I had to know
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Fazer 1000/FZ1 corner / Re: ?? two connectors with the bridging wire ??
« on: 04 November 2012, 09:36:12 pm »
Cheers for that P, looks like some nicked my alarm as well LOL 
!!!!!
Craig
!!!!!Craig
3
Fazer 1000/FZ1 corner / ?? two connectors with the bridging wire ??
« on: 04 November 2012, 08:54:48 pm »Hello Could some tell me what these two connectors with the bridging wire are used for please
and the third also please Apologies if this has been answered before.
Cheers in advance
Craig
4
Fazer 1000/FZ1 corner / Re: exup question
« on: 27 February 2012, 10:45:30 pm »
Hi Mike
Sounds like my servo is on its way out, when you say, direct power for a few seconds and it should spin freely, mine after say one second will turn from 12 o’clock to 3 o’clock slowly.
Can the servo be serviced or is it a sealed unit?
I will try the resistance test this weekend!!
I have just joined the Fazer why of life, so am learning pretty quickly the down side of an exhaust valve that’s not been cared for, after applying plenty of heat and using a press to try and extract the valve from its housing plate, it finally moved, I was beginning to think it had been welded in, plus you could say I was lucky that only one bolt snapped in the exhaust body, opted for the drilling and re-tapping method which worked, rather than using stud extractors, didn’t fancy an extractor snapping.
Big thanks for all your previous post I have read, and for all the post I haven’t read yet, have a horrible feeling I might be.
Cheers
Craig
Sounds like my servo is on its way out, when you say, direct power for a few seconds and it should spin freely, mine after say one second will turn from 12 o’clock to 3 o’clock slowly.
Can the servo be serviced or is it a sealed unit?
I will try the resistance test this weekend!!
I have just joined the Fazer why of life, so am learning pretty quickly the down side of an exhaust valve that’s not been cared for, after applying plenty of heat and using a press to try and extract the valve from its housing plate, it finally moved, I was beginning to think it had been welded in, plus you could say I was lucky that only one bolt snapped in the exhaust body, opted for the drilling and re-tapping method which worked, rather than using stud extractors, didn’t fancy an extractor snapping.
Big thanks for all your previous post I have read, and for all the post I haven’t read yet, have a horrible feeling I might be.
Cheers
Craig
5
Fazer 1000/FZ1 corner / Re: dogbone removel
« on: 15 February 2012, 10:23:45 pm »
And also remember to get another standard side stand as the one fitted to the lowered bike will have been shortened!!
Pages: [1]