old - Fazer Owners Club - old

Bikes, Hints'n'Tips => Fazer 1000/FZ1 corner => Topic started by: nsr500v4 on 02 September 2013, 11:52:43 am

Title: EXUP Valve
Post by: nsr500v4 on 02 September 2013, 11:52:43 am
Are there any articles on lubing the EXUP valve etc on here?
Title: Re: EXUP Valve
Post by: kebab19 on 02 September 2013, 01:15:56 pm


http://fazer1000.yuku.com/topic/1524/EXUP-Valve-Maintenance#.UiSBUX_y0nw (http://fazer1000.yuku.com/topic/1524/EXUP-Valve-Maintenance#.UiSBUX_y0nw)
Title: Re: EXUP Valve
Post by: nsr500v4 on 02 September 2013, 02:12:35 pm
Nice one Kebab!!
Title: Re: EXUP Valve
Post by: Tmation on 02 September 2013, 02:55:03 pm
There was a link in the thread, but worth pointing out again.


This site has an idiots guide to most things FZS Gen 1 (FZ1 in the US)


http://www.cartestsoftware.com/fz1/ (http://www.cartestsoftware.com/fz1/)
Title: Re: EXUP Valve
Post by: Camshaft on 04 September 2013, 11:23:43 am
Are there any articles on lubing the EXUP valve etc on here?


There is bound to be plenty of threads.
My tip is have drill bits and an M8 Tap on hand plus M8x25 High Tensile bolts X 3.
In my case the Valves M6 bolt heads sheared off ridiculously easily really pissing me off causing an M8 re-tap.
The EXUP Cover Bolts were not so much an issue, just one breaking, but 2 have sufficed in bolting that fucker back on.


Oh, copper grease on the 3 HT bolts for easy removal next service sometime down the road. Copper grease aint cheap when you have to buy a container of it needing only need a small amount.
At my local I saw a container for an expensive price so opened the lid to see what it looked like and liked the look of it so much I scooped some of it out using my index finger. Don't tell my mother :lol
 
Title: Re: EXUP Valve
Post by: Hedgetrimmer on 04 September 2013, 12:35:12 pm
You can get copper grease in smaller amounts, this is just the first place I looked. I'm sure I've seen it in tubes (squeezy) too:
 
http://uk.rs-online.com/web/c/?searchTerm=copper+grease&cm_mmc=UK-PPC-0212-_-01_Facilities_Cleaning_and_Maintenance-_-copper_grease-_-copper_grease (http://uk.rs-online.com/web/c/?searchTerm=copper+grease&cm_mmc=UK-PPC-0212-_-01_Facilities_Cleaning_and_Maintenance-_-copper_grease-_-copper_grease)
Title: Re: EXUP Valve
Post by: Camshaft on 04 September 2013, 12:42:25 pm
I dreamt there was no copper grease, I dreamt there was no tubes of it :lol :rollin :rollin
Title: Re: EXUP Valve
Post by: Hedgetrimmer on 04 September 2013, 12:47:16 pm
I dreamt there was no copper grease, I dreamt there was no tubes of it :lol :rollin :rollin

Gen 1 thou owner's nightmare...
I woke up and seized!  :lol
Title: Re: EXUP Valve
Post by: Flyingdeuce on 04 September 2013, 01:30:19 pm
Halfords have a 20g tube.

http://www.halfords.com/webapp/wcs/stores/servlet/product_storeId_10001_catalogId_10151_productId_203941_langId_-1_categoryId_165705
Title: Re: EXUP Valve
Post by: nsr500v4 on 04 September 2013, 03:02:00 pm
I always buy it in small tubes from loads of places, halfords mainly, couiple quid and lasts forever
Title: Re: EXUP Valve
Post by: jackojet on 04 September 2013, 06:26:29 pm
 :lol
Title: Re: EXUP Valve
Post by: solorider on 07 September 2013, 12:45:39 am
unless it has gone up in price recently the cost of a tub of copper grease wasn't that expensive and a lot cheaper than the small tubes in the long run
Title: Re: EXUP Valve
Post by: jackojet on 07 September 2013, 12:09:33 pm
Tubes are great until you put them down, then forget, tred on them and leave a line of copaslip all over the floor.
You then scrape it up and put in a pot.
The tub of copalip I have must be over 20 years old, no mess no fuss ;)
Title: Re: EXUP Valve
Post by: Hedgetrimmer on 07 September 2013, 12:13:08 pm
Tubes are great until you put them down, then forget, tred on them and leave a line of copaslip all over the floor.
You then scrape it up and put in a pot.


Have you tried not doing that?  ;) :lol
Title: Re: EXUP Valve
Post by: VNA - BMW Wank on 07 September 2013, 01:06:41 pm
A tub like this will probably last you a decade or two.  Just over 6 quid, what are youse moanin aboot.

http://www.amazon.co.uk/Comma-CE500G-500g-Copper-Ease/dp/B003BPNOFO (http://www.amazon.co.uk/Comma-CE500G-500g-Copper-Ease/dp/B003BPNOFO)

And it's ease, not grease, or at least it should be.  Be careful where you stick it.

And while you are buying tubs of stuff, if you haven't already get a tub of this to sit next to it on yer garage/shed shelf,

 http://www.demon-tweeks.co.uk/Product.do?method=view&n=2079&p=425233&c=215&utm_source=Google&utm_medium=Base&utm_campaign=Grease&gclid=CKKAi_6fubkCFSTKtAodxQUAJg (http://www.demon-tweeks.co.uk/Product.do?method=view&n=2079&p=425233&c=215&utm_source=Google&utm_medium=Base&utm_campaign=Grease&gclid=CKKAi_6fubkCFSTKtAodxQUAJg) Good to see the Castrol stuff available again.  (no don't put that on yer EXUP)

Title: Re: EXUP Valve
Post by: ChristoT on 07 September 2013, 01:15:58 pm
Be careful where you stick it.


I get into trouble all the time with Exup because of that...  :eek :lol :eek :lol :eek :lol
Title: Re: EXUP Valve
Post by: Hedgetrimmer on 07 September 2013, 01:33:35 pm
Anyway, it's tubes of Autosol you're supposed to step on and get everywhere, everyone knows that.
Title: Re: EXUP Valve
Post by: jackojet on 07 September 2013, 02:27:47 pm
Anyway, it's tubes of Autosol you're supposed to step on and get everywhere, everyone knows that.
Yep done it with autosol aswell :'( :lol
Title: Re: EXUP Valve
Post by: Hedgetrimmer on 07 September 2013, 04:36:11 pm
Anyway, it's tubes of Autosol you're supposed to step on and get everywhere, everyone knows that.
Yep done it with autosol aswell :'( :lol

I'd have to check, but I think it might even be in the instructions!
Something like, "apply with a soft cloth, work in well, become totally absorbed in getting that shine, step back to admire, tread on open tube you put down just behind you".  :lol