old - Fazer Owners Club - old
General => General => Topic started by: Dave48 on 04 June 2012, 09:55:40 am
-
On removing bellypan on my FZS 1000 I discovered radial cracks in the plastic surrounding the rear mounting holes. :'( Front ones have rubber inserts with steel bush so these ok. Rear ones have no anti-vibration bushes/collars-is this correct? Any recommendations re "plastic welding/repair?
-
i had similar problem with the fairing on my fjr ...the btm rear mounts on that were doing exactly the same!!! what i did was trap the bolt between 2 rubber tap washers !! just have to enlarge holes a bit?? job done!! ;)
-
The hugger on my bike had the rear mounting hole wear a way, I repaired it by Evo Sticking a patch of plastic on the inside out of sight. It has held, if this is any help.