old - Fazer Owners Club - old

Bikes, Hints'n'Tips => Fazer 1000/FZ1 corner => Topic started by: Woodzey80 on 05 November 2017, 09:41:03 am

Title: multigauge question
Post by: Woodzey80 on 05 November 2017, 09:41:03 am

Has anyone with the gauge fitted the extra 3rd button for changing between view modes ? If so how do you fit it in laymans terms !?! Thanks

Title: Re: multigauge question
Post by: reggit on 07 November 2017, 08:51:38 pm

Can’t help yet, but I’ll watch with interest! 


I was going to have a play with that wire over winter to see if it was worth connecting. 

Title: Re: multigauge question
Post by: blackcabbie on 08 November 2017, 08:25:08 am

its all on christians multiguage website....... the 3rd button switches 12v onto the outside temperature sensor wire via a resistor and a diode that are soldered onto that wire...... i think i already did this on the  guage i sold you ..... the cct diagram for this is somewhere on christians website...




cheers

Title: Re: multigauge question
Post by: Woodzey80 on 08 November 2017, 12:15:37 pm

The separate circuit board you supplied was for connecting up the fuel calculation feature to the gauge. As for the 3rd button mod you had spliced a wire onto the external temperature sensor but this was just bare & going to nothing. Christians site does show the wiring diagram (with additional resistor & diode) for the 3rd button but does not show where the button fits into the circuit.

Title: Re: multigauge question
Post by: blackcabbie on 08 November 2017, 07:43:20 pm

the bare wire goes to one side of black push button  and the other side of button goes to 12v