old - Fazer Owners Club - old

Bikes, Hints'n'Tips => Fazer 1000/FZ1 corner => Topic started by: solorider on 27 March 2012, 01:15:58 am

Title: Exup cable question
Post by: solorider on 27 March 2012, 01:15:58 am

As some nice last owner disconnected the cables I have to replace them as they were frayed,so the question is does the top cable go to the top of the motor and top of the exup valve? Or do they cross over?

Title: Re: Exup cable question
Post by: Falcon 269 on 27 March 2012, 08:15:44 am

I think the cables are numbered and there's corresponding numbers on the servo motor pulley.

You can get the orientation of the cables at the valve pulley from Pat's Site.

Title: Re: Exup cable question
Post by: eddie on 27 March 2012, 05:07:54 pm

colour coded
 
http://www.cartestsoftware.com/fz1/images/exupcableadjustingnuts1.jpg (http://www.cartestsoftware.com/fz1/images/exupcableadjustingnuts1.jpg)

Title: Re: Exup cable question
Post by: solorider on 30 March 2012, 07:59:34 am

Quote from: eddie on 27 March 2012, 05:07:54 pm

colour coded
 
[url]http://www.cartestsoftware.com/fz1/images/exupcableadjustingnuts1.jpg[/url] ([url]http://www.cartestsoftware.com/fz1/images/exupcableadjustingnuts1.jpg[/url])

The link you supplied did not work,but thanks for the info,in the end I got what I needed from the other fazer owners site http://fazer1000.yuku.com/topic/1524/EXUP-Valve-Maintenance#.T3ValhB5mSM (http://fazer1000.yuku.com/topic/1524/EXUP-Valve-Maintenance#.T3ValhB5mSM) ,it was lucky the owner did not remove the cables from the top as I would have been stuck