Fazer Owners Club - Unofficial
Bikes, Hints'n'Tips => Fazer 1000/FZ1 corner => Topic started by: Timbo on 13 August 2016, 04:54:34 pm
-
Hi All
Could someone please measure the width of the standard bars.
I have just replaced 758 with 754 but cannot decide if they look wider than the standard I remember on my old fazer 1000
Thanks
Sent from my GT-S7275R using Tapatalk
-
26"
758 are 1" wider than standard
-
Thanks Dustydes
-
Your welcome
Just in case you don't know, Renthal 758's so I would guess 754's as well can be tapped out with no drilling to take bar ends.
-
Not knowing anyone in the know, I took my Renthals to an engineering shop to be tapped to take the stock barend weights. He said it needed to be pre- drilled before being tapped, resulting in half an hour workshop time, which wasn't cheap. My pal who doesn't live locally to me, took his to a mate who had the correct tap, and he proceeded to just offer up the tap without pre-drilling. Job done and only cost a few pints. Result!!.