old - Fazer Owners Club - old

Bikes, Hints'n'Tips => FZS600 Fazer => Topic started by: Paulfzs on 30 August 2015, 04:56:59 pm

Title: carbs ballanced.. does it look okay? also video of rev counter...
Post by: Paulfzs on 30 August 2015, 04:56:59 pm
before:
(http://i.imgur.com/oFlEozU.jpg)
After:
far left is a tiny bit out but fixed after this pic


(http://i.imgur.com/vF1lICN.jpg)




Rev counter... not sure if its supposed to fluctuate this much but input?


http://www.youtube.com/watch?v=JYEMYxHYe4c (http://www.youtube.com/watch?v=JYEMYxHYe4c)
Title: Re: carbs ballanced.. does it look okay? also video of rev counter...
Post by: darrsi on 30 August 2015, 05:09:55 pm
It's hunting a bit 'cos it's too low.
With the engine warm it should be around the 1200rpm mark.
Title: Re: carbs ballanced.. does it look okay? also video of rev counter...
Post by: Paulfzs on 30 August 2015, 05:23:40 pm
Ok brilliant, ill get it turned up a bit and let you know.
Title: Re: carbs ballanced.. does it look okay? also video of rev counter...
Post by: Paulfzs on 30 August 2015, 05:47:19 pm
turned the idle up to 1200 still hunting a bit, took it to 2000 and still hunting a little but not as much... putting this down to my carb rubbers.. any glue thatll seal the cracks?
Title: Re: carbs ballanced.. does it look okay? also video of rev counter...
Post by: darrsi on 30 August 2015, 06:25:22 pm
turned the idle up to 1200 still hunting a bit, took it to 2000 and still hunting a little but not as much... putting this down to my carb rubbers.. any glue thatll seal the cracks?


Are you saying you have an air leak?
If so your carbs are falsely balanced.
Title: Re: carbs ballanced.. does it look okay? also video of rev counter...
Post by: Paulfzs on 30 August 2015, 07:16:16 pm
turned the idle up to 1200 still hunting a bit, took it to 2000 and still hunting a little but not as much... putting this down to my carb rubbers.. any glue thatll seal the cracks?


Are you saying you have an air leak?
If so your carbs are falsely balanced.


I dont think i do but the rubbers have small cracks, they dont appear to go all the way through
Title: Re: carbs ballanced.. does it look okay? also video of rev counter...
Post by: darrsi on 30 August 2015, 07:39:45 pm
Silicone
Title: Re: carbs ballanced.. does it look okay? also video of rev counter...
Post by: anutz on 02 September 2015, 03:21:54 pm
where is your wiring connector box? or did you remove it for some reason?
Title: Re: carbs ballanced.. does it look okay? also video of rev counter...
Post by: Paulfzs on 02 September 2015, 03:38:56 pm
where is your wiring connector box? or did you remove it for some reason?


i did an engine change but before i did this i removed the box to get access to the top and then i lost it then found it again.. planned on putting it back but lost it again :D


plus weight reduction
Title: Re: carbs ballanced.. does it look okay? also video of rev counter...
Post by: anutz on 02 September 2015, 03:42:44 pm
where is your wiring connector box? or did you remove it for some reason?


i did an engine change but before i did this i removed the box to get access to the top and then i lost it then found it again.. planned on putting it back but lost it again :D


plus weight reduction


weight reduction eh? i may go and remove mine later  :lol




the carb readings look sync'd mine were a tad out but i never tweaked owt, still runs fine, aside from a rattling chain but waiting for the tensioner to click...
Title: Re: carbs ballanced.. does it look okay? also video of rev counter...
Post by: Paulfzs on 02 September 2015, 03:53:00 pm
dumping the old standard exhaust made a massive improvement on speed and weight, the box just tipped it off and added around 0.01bhp