old - Fazer Owners Club - old

Bikes, Hints'n'Tips => FZS600 Fazer => Topic started by: Dan.C. on 21 June 2015, 08:02:44 am

Title: RPM Signal
Post by: Dan.C. on 21 June 2015, 08:02:44 am

Hello!
Suddenly my old gauges stopped showing me the revs. No problem, cause the new speedometer just arrived.
But, after the install of the new speedo, everithing works just fine, except the revs!
I tried to follow the yellow/black wire and see where it goes but it's a pain. I'll end up striping the entire electrical on my bike.
Can you tell me where I can get RPM Signal and just ignore the factory yellow/black cable?

A few photos of my "Cafe/Fighter" Fazer. Still a lot to be done...

Title: Re: RPM Signal
Post by: clayt74 on 21 June 2015, 10:02:12 pm

Dude...... Please tell me that that custom pipe is not blowing oily gases all over ya rear tyre!!!
Looks sweet but not sure I would ride it?!?!

Title: Re: RPM Signal
Post by: Dan.C. on 22 June 2015, 08:09:55 am

 :D
It is pointing to the right side of the bike :) It's blowing on my right leg  :D

Title: Re: RPM Signal
Post by: Lumpy on 26 June 2015, 08:42:17 am

oily gases? Mine doesn't blow oily gases  :D

Title: Re: RPM Signal
Post by: Hawko on 19 August 2016, 05:33:13 pm

Hello Matey


Was searching through posts, and as I bought same speedo as you have shown here, was wondering if you ever got the RPM sorted, as thats one area that isnt working on mine as well?


many thanks

Title: Re: RPM Signal
Post by: jackw96 on 20 August 2016, 11:19:33 am

When my speedo drive went bad, the speed constantly read 0 and the revs would work intermittently. Would definitely look into that.

Title: Re: RPM Signal
Post by: Hawko on 28 August 2016, 10:25:04 pm

Quote from: jackw96 on 20 August 2016, 11:19:33 am

When my speedo drive went bad, the speed constantly read 0 and the revs would work intermittently. Would definitely look into that.

Ok thanks neither are working at the moment will check,the speedo coupling on the front wheel


Cheers