old - Fazer Owners Club - old

Bikes, Hints'n'Tips => FZS600 Fazer => Topic started by: Brettholmes89 on 16 March 2015, 09:41:41 am

Title: Fork seal sizes
Post by: Brettholmes89 on 16 March 2015, 09:41:41 am

Hi
Does any know the sizes for the fork seals?

Title: Re: Fork seal sizes
Post by: darrsi on 16 March 2015, 09:48:46 am

They'll just be per bike rather than szes i'd have thought.


Try on here.


http://www.wemoto.com/bikes/yamaha/ (http://www.wemoto.com/bikes/yamaha/)

Title: Re: Fork seal sizes
Post by: rhinoeli on 16 March 2015, 10:01:55 am

41 x 53 x 8/9.5

Title: Re: Fork seal sizes
Post by: Brettholmes89 on 16 March 2015, 06:01:57 pm

I wanted the sizes so I could go to a seal shop and get the same thing for £2 rather than "super special Yamaha fork seals" for a tenner

Title: Re: Fork seal sizes
Post by: darrsi on 16 March 2015, 07:19:58 pm

Seriously, for that sort of money just buy the real thing!

Title: Re: Fork seal sizes
Post by: darrsi on 16 March 2015, 07:22:10 pm

Otherwise you'll end up with these.  :lol

Title: Re: Fork seal sizes
Post by: Brettholmes89 on 16 March 2015, 08:47:36 pm

They're exactly the same... Yamaha etc just over charge for them because they're "Genuine Yamaha"

Title: Re: Fork seal sizes
Post by: rhinoeli on 16 March 2015, 09:00:39 pm

I have ~20000 kms on standard seals bought by the sizes above. No problems yet.

Title: Re: Fork seal sizes
Post by: adeejaysdelight on 17 March 2015, 12:31:01 pm

I agree. Its the same for nuts, bolts, washers, bearings and gaskets. Yamaha (and everyone else) rip the arse out it when you can buy perfectly good quality, British or Japanese made, stuff for buttons.

Title: Re: Fork seal sizes
Post by: Brettholmes89 on 18 March 2015, 11:57:58 am

Worst part is Yamaha etc don't even make them, they just buy them from the same places and put them in nice little genuine Yamaha bags!

Title: Re: Fork seal sizes
Post by: rhinoeli on 18 March 2015, 07:02:23 pm

Did you miss my reply? Seal size is: 41 x 53 x 8/9.5 (mm)

Title: Re: Fork seal sizes
Post by: Brettholmes89 on 19 March 2015, 09:30:25 pm

Thanks very much!