old - Fazer Owners Club - old
Bikes, Hints'n'Tips => Fazer 1000/FZ1 corner => Topic started by: silver-sloth on 14 March 2015, 11:44:31 am
-
OK, starting my "second life" on FOC-U with a cry for help!
Bike is a 2003 FZS1000
I recently put new clutch plates in and also a new clutch cable (also did an oil change at the same time). When the bike is warmed-up, the clutch is fine, but when its cold, the cable has tightened-up taking the play out of the run and the clutch draggs really badly and won't fully disengage. Once it warms up after a couple of miles, the cable slackens-off to give the correct play and the clutch works fine again
Any suggestions or assistance will be much appreciated.
Cheers,
Jon
-
Hi and welcome back. :)
Genuine Yamaha clutch cable or pattern part? The latter have a reputation for causing clutch adjustment issues.
-
Also
check the following -
- the clutch basket for wear on the finger where the friction plates rest against it.Will cause clutch drag, (because the clutch isn;t fully disengaging) which can then make it hard to find neutral.
-
Also check if the end-plug is missing from the clutch main-shaft -
- http://foc-u.co.uk/index.php/topic,13825.0.html (http://foc-u.co.uk/index.php/topic,13825.0.html)
-
I had this plug problem on one of mine before aswell.
-
Thanks for the suggestions folks, much appreciated.
Jon
-
Ignore this post - now sussed it! (Don't know how to delete the post, so mods, please feel free to delete it - Ta)
Jon