Fazer Owners Club - Unofficial
Bikes, Hints'n'Tips => For Sale & Wanted => Topic started by: Dave48 on 08 November 2014, 01:19:42 pm
-
For anyone contemplating brake service/overhaul I can supply 20gm tins of these.
Red Rubber Grease OR copper grease (1 tin) cost £2 posted
Both products 2 tins) £3 posted
Paypal preferred. PM me if interested.
-
Still have a few tins of the above if anyone wants?
-
For anyone contemplating brake service/overhaul I can supply 20gm tins of these.
Red Rubber Grease OR copper grease (1 tin) cost £2 posted
Both products 2 tins) £3 posted
Paypal preferred. PM me if interested.
Where is the red rubber grease used Dave?
What's used for the swingarm pivot?
-
Red rubber grease is used for the brake pistons mate. YOu could use it for the swingarm but its a bit pointless - normal lithium grease is whats normally used on bearings as its good and cheap!
-
Red rubber grease is used for the brake pistons mate. YOu could use it for the swingarm but its a bit pointless - normal lithium grease is whats normally used on bearings as its good and cheap!
As Joe says,Andy.
A light smear of redrubbergrease on the outside of the brake caliper pistons,helps keep out the water & s**t that eventually leads to seizing/sticking brake pistons, also helps piston/rubber seal interface.
Copper grease on back of brake pads(sparingly) and on any fastener that might be liable to corrode /seize-again only v. little needed.
Steering bearings, swing arm & rear suspension pivots-Lithium based grease as per Yamaha manual.
-
Hi i will take a tin of each if you have any left Cheers Dave :)
-
Hi i will take a tin of each if you have any left Cheers Dave :)
PM sent, Dave48