old - Fazer Owners Club - old

Bikes, Hints'n'Tips => Fazer 1000/FZ1 corner => Topic started by: PaulSmith on 22 March 2014, 05:04:16 pm

Title: Venhill exup repair kit
Post by: PaulSmith on 22 March 2014, 05:04:16 pm

I bought the venhill kit to replace a frayed cable exup cable. I got the old one out and put the new one in and it took maybe ten minutes, then I cut it too short.  My fault, I forgot to measure twice before cutting.

Could I get the second cable in? Not a chance! Over an hour later and I have given up. How the hell do you stop the end of the cable from fraying and snagging, stopping it from going through ?

A second question? Should I be using locktight or something on the screw holding the cable in the nipple? Given the heat and vibration, I cant see how it would stay in place? 

Title: Re: Venhill exup repair kit
Post by: Topcat2006 on 22 March 2014, 09:31:14 pm

I normally solder the cable before I cut it when replacing them. 

Title: Re: Venhill exup repair kit
Post by: Davebo on 22 March 2014, 11:02:14 pm

Someone said dip the end in wax to thread it through.

I didn't.