This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - riddleofsteel
Pages: [1]
1
« on: 16 January 2021, 04:50:38 am »
Anyone happen to have any suitable dog bones for sale?
Or know a good source for some?
Cheers
2
« on: 19 April 2020, 03:08:05 pm »
I noticed today when pinning it in first/second, that when the bike hits the rev limiter, it doesn’t just bounce off it until I change gears, it seems like there’s a sudden loss of power and the bike slows/bogs and drops revs.
Is this normal? Or indicative of a problem?
When you say rev limit, do you mean on the rev counter?
Also, not sure if it’s related, but I’m getting a lot of popping in the exhaust, particular under deceleration/engine braking.
Cheers!
Your fuelling is all to cock, either an air leak somewhere or some ones been playing with, needles/jets, airbox/filters and or end cans.
Does the bike have a AM endcan/exhaust, is there an air box i.e. is there rubbers at the back of the carbs going into an air box or just filters on the back on the carbs?
I mean when I hit the bike’s maximum rpm on the tacho.There is an aftermarket exhaust, the air box and filter are still in place. Does the popping suggest a lean condition over rich? I’ve suspected there may be some leaks around the rubber carb joints, a bit of carb cleaner sprayed around them at idle does change the rpm a bit
3
« on: 19 April 2020, 12:07:04 pm »
Hey guys, new to my 98 FZS600 (and carby bikes in general) so apologies if this is something simple/covered already.
I noticed today when pinning it in first/second, that when the bike hits the rev limiter, it doesn’t just bounce off it until I change gears, it seems like there’s a sudden loss of power and the bike slows/bogs and drops revs.
Is this normal? Or indicative of a problem?
Also, not sure if it’s related, but I’m getting a lot of popping in the exhaust, particular under deceleration/engine braking.
Cheers!
4
« on: 19 February 2020, 10:27:50 pm »
Gday lads, just joined up here and just purchased a 98 Fazer 600 a couple of weeks ago.
Purchased an 08 R6 shock to install, but don’t have any of the other stuff (new dogbones, the top spacers, heavier spring).
Does anyone have any of this for sale, or know any good sources to supply them?
Cheers!
Pages: [1]
|
Show Posts
