Fitted my some Oxford L.E.D turn signals today. After much pissing about with resistors and stupid Yamaha connections I finally got them working but then to my dismay realised they don't fit without some kind of spacer/blanking plate?I've used the stock bases for now but looks awful. The back will need something similar too,Does anyone know what I'm looking for?
I fitted a Tutoro chain oiler on the 'winter' 600 this morning. At dinnertime I went for a 20 mile spin to check the flow rate. I had to decrease it a bit. Started raining half an hour after I got back. I shall tidy the zip ties up in the morning and, weather permitting, go for a longer ride to fine tune it..
Quote from: Dudeofrude on 11 January 2018, 09:35:56 pmFitted my some Oxford L.E.D turn signals today. After much pissing about with resistors and stupid Yamaha connections I finally got them working but then to my dismay realised they don't fit without some kind of spacer/blanking plate?I've used the stock bases for now but looks awful. The back will need something similar too,Does anyone know what I'm looking for?Yep. You need these. I bought these for my 2008 Gen 2 a couple of years ago. Got mine from M&P's though, not this American site and they were cheaper. Maybe contact Oxford direct and find out where your local dealer is. https://www.motosport.com/oxford-indicator-spacers?mmy=yamaha%3Bfzs1000%3B2008&mmy_source=pdp
That is much neater than my routing effort, mountaingoat. I shall have to have a rethink.
Thanks for that, Fazerider. All suggestions are welcome.
Decided to finally bleed my rear brake... Found an old bottle of "turtle wax" while looking for my bleed kit so gave it a wash and wax, then clocked a really old bottle of brasso polish so did the silencer! Proper shiney...
Quote from: NorthWestern on 14 January 2018, 07:21:05 pmDecided to finally bleed my rear brake... Found an old bottle of "turtle wax" while looking for my bleed kit so gave it a wash and wax, then clocked a really old bottle of brasso polish so did the silencer! Proper shiney...But did you get around to bleeding that brake?
Installed my new rear L.E.D turn signals and finally wired the tail light indicators in. It's very obvious that I'm indicating now 🤗
Quote from: Dudeofrude on 15 January 2018, 03:44:06 pmInstalled my new rear L.E.D turn signals and finally wired the tail light indicators in. It's very obvious that I'm indicating now 🤗It is obvious that you are indicating, what is not obvious is which way your going