I need to replace the rear brake disc on my FZ6, but, despite using a heat gun and then a blow torch, I can't get the bolts that hold the disc on the wheel to move (probably because they haven't been undone since the bike was made) and now the allen heads are starting to strip out.
I don't want to use a dremel to cut slots in them until that's the only option, so I've ordered an impact driver and I've had people on Facebook suggest hammering in a torx bit, but I want to keep the brute force options until I've exhausted all the others.
Earlier today I squirted them with a load of brake cleaner (which is supposed to dissolve threadlock) and now I've left them soaking with Plusgas, so tomorrow I'm going to give them another go with the blowtorch, but does anyone else have any useful suggestions?