Date: 03-05-24  Time: 13:14 pm

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Rich74

Pages: [1]
1
FZS600 Fazer / Carb float height
« on: 26 May 2020, 01:24:34 am »
I have tried to set the float height using the tube method and there was no way I could get near the 4.5mm above the mating service. I have tried setting the floats using a ruler to 14.00mm with the floats on the resting position and the bike run worse than it was before. I will try setting them to 11.00mm tomorrow to see what happens. So while I am taking the carbs off again for about the tenth time, do any of you guy's know what height measurement has worked for you?


Your help will be much appreciated.


Richard

2
FZS600 Fazer / Help! No gear selection
« on: 15 April 2020, 08:12:26 pm »
I had the engine out for a repaint and took all the engine covers off at the end of last year and have put it all back together this week and put the gear selector on and it won't shift up or down, it just feels solid. Can't think of anything I have done for this to happen.
Your help would be much appreciated.












































3
FZS600 Fazer / Rear shock absorber upgrade
« on: 07 July 2019, 10:08:17 pm »
I am looking at upgrading the rear shock absorber on a mk1 fazer 600 and believe a R6 one will fit, but what year R6 shock absorber am I looking to buy, that will fit?


Cheers,


Richard

4
FZS600 Fazer / Cylinder head removed
« on: 26 December 2018, 08:57:13 pm »
I have removed the cylinder head and when doing so the cylinder below, which I always call a barrell cylinder, has moved.
If anybody has done a cylinder head job before, have you removed both cylinders and replaced both gaskets?

Pages: [1]