Fazer Owners Club - Unofficial
Bikes, Hints'n'Tips => Fazer 1000/FZ1 corner => Topic started by: Loz on 15 June 2013, 11:57:02 am
-
I would like to get a slightly small number plate but it looks like it might look a bit naff on the original under tray unit, has anyone cut their undertray down and if so can it be done neatly and what did you use to do it ? :)
-
Trimed mine with a dermal but a hack saw would have been better as the dermal melted it rather than cut it. So then needed to go over it to clean it up.
I didn't trim mine a huge amount but I have seen others hack it back a long way.
2 words or caution, 1 you need a reflector so do as I did and leave the old one in place on its tab or as others do and stick a stick on one on the plate itself.
2 even cut back a little and you get a LOT more spray up the back. I meen a LOT :P
Will try to find a pic of it.
-
(http://i7.photobucket.com/albums/y270/ghostbiker/Fazer/mods/IMGP0066.jpg)
(http://i7.photobucket.com/albums/y270/ghostbiker/Fazer/mods/IMGP0068.jpg)
-
I cut mine back to just shorter than the number plate and stuck the reflector under the light where is says yamaha with double sided sticky tape.
-
Trimmed mine with combination of sharp knife & cutting disc on grinder. Had to heat the housing where my indicators now bolt to get them straight & remount the reflector but I think it was worth the effort. Marked it with masking tape before cutting to be sure I liked the lines.
(http://i68.photobucket.com/albums/i10/hairyhampton/Image0946_zps460f86a0.jpg)
(http://i68.photobucket.com/albums/i10/hairyhampton/Image0929_zpsadc4f69b.jpg)
(http://i68.photobucket.com/albums/i10/hairyhampton/Image0947_zps00fdc349.jpg)
-
(https://lh6.googleusercontent.com/-uD6HQTN_VtQ/T4q93QWZlMI/AAAAAAAAAPo/HksIK5iMikY/w370-h600-no/1209-1.JPG)
-
Thanks for all the tips and pics, they have been really helpful, going to order the plate tonight and then get cutting :eek