1
Fazer 1000/FZ1 corner / Re: Rev Counter 0 to 3k
« on: 15 January 2013, 01:24:26 pm »
Header pipes and exup valve replaced, TPS replaced. Now thats better, no lurching just smooth power and acceleration.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
Fazer 1000/FZ1 corner / Re: Rev Counter 0 to 3k« on: 15 January 2013, 01:24:26 pm »
Header pipes and exup valve replaced, TPS replaced. Now thats better, no lurching just smooth power and acceleration.
2
For Sale & Wanted / Re: Breaking fzs 1000« on: 10 January 2013, 09:06:38 am »
TPS arrived safely. Thanks
Regards Andy B 3
Fazer 1000/FZ1 corner / Re: Rev Counter 0 to 3k« on: 03 January 2013, 04:08:50 pm »
Pipes are off and waiting for me to take to an engineer, also managed to buy another set which are good and will go back on tomorrow £100 for second hand set The piece on the back of the pipes was broken off so needed welding anyway.
Thanks for all the advice. 4
For Sale & Wanted / Re: Breaking fzs 1000« on: 31 December 2012, 08:21:47 pm »
I am interested in the downpipes and EXUP?
5
Fazer 1000/FZ1 corner / Re: Exup system« on: 31 December 2012, 08:15:25 pm »
I am in exactly the same position I removed the cover from the exup to find a completely seized valve (which has been damaged beyond repair and to top it off the bolts have all sheared. I priced up new and it came in at £1193.71 for the pipes and another £500 ish for the valve. I to have looked at the non EXUP downpipes on ebay at £220ish and wonder if this is the only affordable way around...... I have had the bike just over a week and feel the fault was known about when I was sold the bike. Wish I had been on here and looked up the EXUP problems.
6
Fazer 1000/FZ1 corner / Re: Rev Counter 0 to 3k« on: 31 December 2012, 11:00:27 am »
Motherf****r..... I removed the exup cover (which came off extremely easily!) the pulley has been removed and presumably binned, the valve was seized and the with the greatest will in the world I still managed to shear off all three bolts *!*&%$!£***
7
Fazer 1000/FZ1 corner / Re: Rev Counter 0 to 3k« on: 28 December 2012, 01:17:01 pm »
Thanks, I will take a look whilst I am servicing it tomorrow.
8
Fazer 1000/FZ1 corner / Rev Counter 0 to 3k« on: 28 December 2012, 10:26:49 am »
Hi, I am new to the forum and new to my gen 1 fazer. I have owned the bike for just over a week. I purchased it privately and rode it 50 miles home without issue. When I rode it to work on day two of my ownership it seemed to be hessitating below 3000rpm but if i gave it a handful of throttle it would pull hard with no problems. I have bought a service kit and intened to go through it this weekend. This morning on the way to work the rev counter suddenly dropped to 0 and then went up to 3k where it stayed for a couple of seconds and then returned to normal. After this had happened the bike was very smooth with no hessitation!!!! then the hessatation returned and a few miles later everything repeated itself (smoothing out again after the faukt had been shown). Ant thoughts greatly appreciated.
Pages: [1]
|