Date: 28-03-24  Time: 11:25 am

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - alchemyx

Pages: [1]
1
FZS600 / Where that oring goes??
« on: 17 July 2016, 06:19:53 pm »
Hello,


Trying to fix my carbs with following set (attached). Question is - where does smallest oring go? I have no idea and it seems impossible to find inside manual (too low resolution). Can you help?


Thanks




2
FZS600 Fazer / FZS600 2000 ignition cables
« on: 13 June 2016, 06:17:07 am »
Hello,


For about two years I had issues with ignition of my FZS 600 ('2000). Usually after rain it had trouble with working unevenly (defnitely not all plugs were giving proper sparks). So I replaced all spark plugs and it helped for a little while. Now it started again and it happens only after rain or washing. Last time after rain it would even start (starter was working fine but firing) I had to give it some acceleration before it would start.


So I think that time has come to replace cables or seal them with ignition sealer. What do you think? If I had to replace them do I need to do that with coils? They are glued together with cables.


Any help would be appreciated. Thanks!


3
FZS600 Fazer / Voltage and dying battery
« on: 02 September 2015, 08:21:27 pm »
Hello, long time no see :)


I am having trouble with battery lately. After I charge it with charger and drive motorcycle for a while it has some trouble starting (I can see it almost does not start up, and if I try to start it few times in a row it can't do it after second or third time.


So my guesses were - faulty battery, faulty electric installation (shorted) or something with charging. So it did test:


- battery after charging with external charger and leaving for a while - 12.6V
- while starting motorcycle from fully charged battery - voltage drops for a while to about 9V (and when I do it second and third time it drops to about 7V)
- when idling and everything turned off - 14.4V
- with lights on and idling - 13 V
- with high beam and idling - 12 V and dropping


So what are your guesses - are voltages are OK on idle? I thought it always would be 14.4 even with lights (because voltage regulator should turn it up?)


Thanks!

4
Introduction / Hello again!
« on: 20 March 2012, 10:17:13 pm »
Been here on previous forum, so I am back here also. re-Hello!

5
FZS600 Fazer / Odometer pinouts
« on: 20 March 2012, 10:16:45 pm »
Hello,


Do you maybe know pinouts of Fzs 600 '00 odometer pinouts? I am planning to connect some DIY electronics to it - I need to read RPMs, speed and neutral. I need to count cycles from front wheel and from ingintion, but don't know which cables do what :).


Thanks!

Pages: [1]