This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Will.I.Is
1
« on: 25 April 2013, 11:54:54 pm »
To my Fazer!! 
2
« on: 02 April 2013, 11:07:50 am »
Check the sprocket carrier bearing isn't dead, I noticed mine was buggered when i put new rubber on and I have a similar noise so that will be done next week with the service. I'll report back if it solves it!
3
« on: 13 March 2013, 10:22:25 am »
The benefit of iridium is because the electrode is smaller you get a stronger more reliable spark than on a standard plug and they last longer.
5
« on: 09 March 2013, 08:38:12 am »
I have a similar problem with dog solids in the lane behind my house, literally just behind MY HOUSE! one of the neighbours is letting their dog sh*t in the ally and not clearing it up. I will find out who it is and sling it at their house with a shovel!
6
« on: 09 March 2013, 08:31:43 am »
I use a Nolan N62 and I either don't notice the noise or am deaf already 
7
« on: 09 March 2013, 12:29:02 am »
Ha ha 599cc's of snarling death!
8
« on: 08 March 2013, 10:01:02 am »
New Mirrors and bar ends are now here, all I need is the engine case and gasket and I can give back the Pan 
9
« on: 07 March 2013, 11:47:32 pm »
I did a noise test earlier and it's actually quieter than the beowolf can I had on before it was knocked over. also my MOT tester and the police are quite relaxed about the noise. As long as it doesnt say not for road use it won't fail an MOT the only reason it says "not road legal" is because it doesnt come with a baffle, if it does become an issue I can fit one.
10
« on: 07 March 2013, 12:04:11 pm »
11
« on: 06 March 2013, 11:02:53 am »
Off to the shop I go then!
12
« on: 06 March 2013, 10:55:30 am »
have you had the front wheel out at all?
13
« on: 06 March 2013, 10:54:49 am »
14
« on: 06 March 2013, 10:42:20 am »
My new exhaust arrived today and the other bits will be here later, engine case by the end of the week! I should be back on the Fazer by the weekend.    All I gotta do then is clean the beast and touch up a few bits of flakey paint with the couple of weeks off I'm getting later in the month!
15
« on: 04 March 2013, 01:33:05 am »
looked at it and sulked 
16
« on: 01 March 2013, 04:35:49 pm »
Ha ha no I like things sorted fast and the company they were with is admiral, I'm with bikesure who I have to say were a delight to talk to, they listen and understand the pain of your love going under a vauxhall meriva
17
« on: 01 March 2013, 02:46:01 pm »
All sorted her insurance company called and have given me £620 to fix my bike. It's a bent exhaust and some scuffs on the engine case bar ends and mirrors. Obviously the bill was done by genuine parts and fitted at dealer
18
« on: 01 March 2013, 01:04:13 pm »
Just phoned bikesure to get it sorted and it will all go through their insurance, in the mean time i'm borrowing a pan european 1100 to commute and i have to say it's like a big comfy armchair lol
19
« on: 01 March 2013, 12:41:22 pm »
Bloody hell! its now going through insurance so it'll be ages before it's sorted! my bike was parked and I was in bed asleep at the time! her parents are more concerned about the scuff on the car as opposed to the foccing motorbike she dragged down the road!!! and she couldnt drive off as my side stand had latched onto her bumper! I really hope they dont write it off!! Pretty angry again now.
20
« on: 01 March 2013, 12:16:25 pm »
21
« on: 28 February 2013, 11:56:11 pm »
rode to work like my hair was no fire, rode home from work like my hair was on fire 
22
« on: 27 February 2013, 10:29:29 am »
135.8 was on the limiter, I've had my speedo reading 140+ but you need to allow for inacuracys at that speed, thats all the gearing allows unless you change the rear sproket for a smaller one but then you will lose acelleration
23
« on: 27 February 2013, 10:22:58 am »
 This was running rich with a touch of clutch slip hence the dip about 9 seconds in the slip has now gone away so I want to take it back up to get a better reading over the rev range
24
« on: 27 February 2013, 10:12:17 am »
because of the gearing it will only do 135.8 which is what mine topped out on the dyno, it does feel like it needs another gear, I have no doubts if 4th 5th and 6th were a little taller it would do 150
25
« on: 25 February 2013, 10:58:27 pm »
How much you looking for it?
|
Show Posts
