Fazer Owners Club - Unofficial

Bikes, Hints'n'Tips => FZS600 Fazer => Topic started by: YamFazMan on 30 June 2013, 03:23:57 pm

Title: How the hell do you remove the Cambox Cover ???
Post by: YamFazMan on 30 June 2013, 03:23:57 pm

Hi
I'm about to check the valve clearances 24000 mile service, All the bolts removed, Cambox Cover loose  But How the hell do you remove it from the bike ???.
 
ATB YFM

Title: Re: How the hell do you remove the Cambox Cover ???
Post by: Punkstig on 30 June 2013, 04:52:18 pm

Unless you're having problems with the bike running don't even bother checking them at 24000, both my fazer and thundercat were run past 120,000 without them being done!

Title: Re: How the hell do you remove the Cambox Cover ???
Post by: His Dudeness on 30 June 2013, 05:22:48 pm

You might have to remove the bolt holding the thermostat in and wiggle it out of the way to get a bit more room

Title: Re: How the hell do you remove the Cambox Cover ???
Post by: YamFazMan on 30 June 2013, 06:00:29 pm

Hi
 
Thanks for the reply's I tried the thermostat bolt "No joy" so I held the cover open with a small block of wood under each corner and checked the clearances like a gynaecologist  :)  All the clearances were in-spec  :D 
 
Thanks again ATB YFM 

Title: Re: How the hell do you remove the Cambox Cover ???
Post by: His Dudeness on 30 June 2013, 06:10:17 pm

Well done. Didn't know gynaecologists used blocks of wood :lol