What the FOC is it with Yamaha's designers that they like to bury parts of the bike in ridiculously inaccessible places on their bikes, such as putting a clip that holds the clutch cable deep inside the frame meaning you need to lift the tank and take out the airbox to get to it?!
Today, after previously having a nightmare of a job getting the "ABS Modulator Cover Plate" out to take off the old brake pipes (which involved removing the rear wheel, rear shock and exhaust pipe mid-section), I was trying to put bits back together again.
I was trying to reconnect the front brake system with the new braided pipes, but the connectors to the hard pipes from the ABS modulator are, again, stuck behind part of the frame, so there's no way to tighten them up properly when they're in place (and, of course you don't want them leaking!)
The only way I could secure them was to connect the braided pipes loosely to the hard pipes, feed the whole lot through a gap in the frame manoeuvre them around to figure out exactly what position they needed to be in, then take the whole lot *out* again, so I could tighten up the bolts and put it all back once more!