1
General / Re: Downloads section missing
« on: 02 June 2024, 10:46:42 pm »I broke it whilst fixing another issue we had - still trying to find a way of recovering it.Do you have any backups? You should be able to restore it from the backup
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I broke it whilst fixing another issue we had - still trying to find a way of recovering it.Do you have any backups? You should be able to restore it from the backup
Thanks for the info,will measure the thread all along when I'm swapping the nuts early next week.I fixed mine by cutting a slot on the shaft and drilled a hole at the end to put a bolt and washer in it. I put what I did in the downloads section, but it seems to be missing.File also explains what else to do to prevent it falling off and stranding you if the fix failsDid this at 71000miles and now 99600miles and had 2 sprocket changes since and thankfully still good.
After all that it’s the fuel level in the #3 float bowl, that’ll teach me for assuming!!Why did you adjust the float levels?
Disassembled the engine, removed the gears. TBH the gear dogs didn't seem too terrible, but if it jumps out of gear what can I do...I was lucky to find a low mileage gearbox from a '94 FZR600R, and combined the best gears into a working unit. The 2nd gear pinion is a b**** to remove and install... Now I wait for some Loctite sealant, then I'll reassemble the engine.Just for my own entertainement, added the costs of necessary parts together, if everything was new. Wow. Good thing that almost everything's available new, but a complete transmission overhaul, some crankshaft bearings, a complete gasket set adds up to the value of my bike, even if every work is done by me.Jumping out of gear can be caused by broken spring on the Shift Drum or Shift Shaft or both. I remember someone on here a long time ago and he had a bend on the drum rotating mechanism on the shift shaft which was causing his gear lever not to full rotate the drum to the next gear
To lower the electrical load I have fitted LED lights - made a massive difference.Same here and I replaced the White connector with Anderson powerpoles.