1
FZS600 Fazer / Re: Front brake light switch
« on: 08 September 2016, 05:06:19 pm »
Thanks. I might have to try that
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Ha! Nice pic
I still can't turn the setting from 1. Won't budge at all.
Are you pushing the lever away from the bar before trying to turn the dial? If not, it wont turn as the pin will be in the detent.
Yes, I am. Won't budge. Maybe it's seised. Not too bothered at the moment. Would be nice to adjust it though.
Easy enough to do, but before you do ensure the hole in the clutch lever is not elongated from use, because if it is your wasting your time until you replace it.
Screw in the cable adjuster full at the lever end.
Remove the rubber bung on the sprocket cover
Loosen the lock nut with a deep spanner ( it will loosen with a crack and frighten the crap out of you)
Turn the lock nut anti clockwise a full turn
Hold you fingers lightly on the clutch lever
Turn the centre screw clockwise with a good fitting flat screwdriver
You will feel the lever moving out
Keep turning the screw until the lever is about 5 to 6mm from the lever housing.
Tighten the locknut.
Replace the rubber bung
Take the final adjustments at the cable adjuster
Read this post also http://foc-u.co.uk/index.php/topic,10124.msg105622.html#msg105622
Ha! Nice pic
I still can't turn the setting from 1. Won't budge at all.
Are you pushing the lever away from the bar before trying to turn the dial? If not, it wont turn as the pin will be in the detent.
It is adjusted to the end of the lever screw thread. Not sure how easy it is to adjust at the other end. Is it easy enough to do?
I'm baffled how you haven't already adjusted it before now?
Mine sometimes does the same accelerating hard uphill. Oil level at the max mark when on the centre stand on level ground.Put your own eggcup full in and see
Would like to know if your eggcup did the business.