Date: 29-03-24  Time: 07:27 am

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - NikolaFazer

Pages: [1]
1
FZS600 Fazer / Re: Rear tire 180?
« on: 05 March 2016, 12:19:36 am »

Luckily that part doesn't need any improvement. Thank you for your suggestion.
Just looking a way to improve my bikes look. Cheers.

2
FZS600 Fazer / Rear tire 180?
« on: 04 March 2016, 11:57:13 am »
Hey folks, it's time to change tires and I want to put 180 mm rear tire. Is it possible? There is enough space between tire and rear fork, but not too much between tire and chain. Did someone managed do fit it?

3
FZS600 Fazer / Re: Neutral switch
« on: 15 February 2016, 05:25:32 pm »
What are "diodes around starting circuit"?
Everything else is working just fine...
It works fine when I disconnect the sidestand.
Do you see anything suspicious? Cuz I don't...

4
FZS600 Fazer / Re: Neutral switch
« on: 14 February 2016, 05:18:05 pm »
Problem, again. The same one...
Neutral is always ON! Well, almost always...
Neutral light is OFF only when it's in gear AND the side stand is DOWN. When I pull the sidestand up, the Neutral light goes ON. I really don't get it... Does someone know what's causing the problem?

I should mention that sidestand kills the engine when I push it down and it's in gear...

5
FZS600 Fazer / Re: Neutral switch
« on: 14 February 2016, 11:56:41 am »
No, you didn't understand, the LED bulbs are just for background lights. I figured it out, it was a bad contact on the switch, or the wire was touching ground. Works fine now...

6
FZS600 Fazer / Re: Neutral switch
« on: 12 February 2016, 01:02:07 pm »
Hey guys, I have a problem again... The neutral light is always ON! Is it a faulty switch then?

7
FZS600 Fazer / Re: Neutral switch
« on: 10 February 2016, 04:40:34 pm »

Thank you for help guys, got that neutral light fixed (yes, it was a bulb), and LED background installed.
 Looks good with my temp gauge that I installed few days ago :)


PS, sorry for the low quality photo.






8
FZS600 Fazer / Re: Neutral switch
« on: 09 February 2016, 07:17:31 pm »
Yes, I figured it out... I'll buy the bulbs tomorrow for the instrument cluster background light, so I'll change them all.
Thank you for help! :)

9
FZS600 Fazer / Re: Neutral switch
« on: 09 February 2016, 01:22:32 pm »
I just found a similar topic and how to take off the bulbs. The bulbs are T5, right?

10
FZS600 Fazer / Re: Neutral switch
« on: 09 February 2016, 10:12:40 am »
Thank you very much!

Yes, I can start the bike with the side stand down, so the switch is fine, right?
Is there some fuse for neutral light?

11
FZS600 Fazer / Re: Neutral switch
« on: 08 February 2016, 10:45:38 pm »
Thank you! :)
Contacts under the plastic cover on the left side are okay, but I didn't check the bulb because I thought it's a LED indicator. Do I have to take of the whole gauge off and disassemble it to check the bulb or there is an easier way?

12
FZS600 Fazer / Neutral switch
« on: 08 February 2016, 07:37:13 pm »
Hey guys, I'm new on this forum, so don't mind if there's a same topic (I can't find it).


So, I just got my Fazer 600 2001 and the neutral switch does not work. I located the switch on the left side close to gear changing lever. My question is do I have to drain the oil out of the engine when removing the neutral switch?
And is there a way to repair the faulty switch?

Sorry if there's some spelling mistakes, I'm from Serbia :)

Pages: [1]