General > General

Carbtune Virgin

<< < (2/3) > >>

dickturpin:
Thanks Ghostbiker....but please enlighten me...what's the carb crossover mod?

ghostbiker:
http://www.cartestsoftware.com/fz1/carburetorequalizationmanifold.html


I did a simpler version if i remember right, it just involved 2 lengths of pipe linking the 2 outside together and the 2 inside together, useing same lengths of pipe.
but without looking i cant be sure as i did it a few years back.

ghostbiker:
ahh yes, at the bottom of the page i linked is .....


Bill Jinks now recommends an simpler manifold as an alternative. Use two lengths of hose to connect cylinders 1 to 4 and 2 to 3 separately. The benefits from this setup may be nearly equal to the more complex four-way manifold. It also has the benefit of eliminating all the connections made necessary by the 'T' connectors and the additional potential of air leaks.

this is what i did.

dickturpin:
Thank you GB, read the thread now. i assume you haven't a Scottoiler drawing off one of the stubs?

ghostbiker:
My scottoiler draws from a carb boot, which one i cant say as again i havent had to touch it in a couple of years.
if i remember right it has a brass spiggot drilled into it and the oiler runs off that

Navigation

[0] Message Index

[#] Next page

[*] Previous page