Fazer Owners Club - Unofficial
Bikes, Hints'n'Tips => Fazer 1000/FZ1 corner => Topic started by: greg1953 on 06 September 2021, 09:41:07 am
-
Many recommend Renthal 758 as an improvement on the Gen 1 Fazer 1000...can anyone advise ? are they lower or higher than standard ? Thank you.
-
They are about the same height as the originals but a little straighter i.e. not as swept back. The original bar end weights do not fit the Renthals and you will have to drill a hole for the switch gear locating pin. They are good though once you get used to them. :D
-
Get a thread tapped in the end of the Renthals, 16mm at 16 t.p.i, to fit the original bar end weights, which are quite heavy (308 grams) and do a good job.
-
Thanks for the replies.
-
The Sweep / pullback of the 758 bars feels comfier (to me). I also tapped mine out & fitted heavier FJ1200 bar ends to minimise the vibes.
-
I tapped the end of mine and fitted the original bar ends