Date: 15-06-24  Time: 11:33 am

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - flakey

Pages: [1] 2 3
1
For Sale & Wanted / Re: FZS 600 fazer 2001 breaking most parts available
« on: 23 September 2016, 10:04:07 pm »
do you still have a set of the original 6 clutch springs please?

2
FZS600 Fazer / Re: Clutch draggin when hot
« on: 15 September 2016, 05:02:11 pm »
hi tex1507, glad your clutch problems are all sorted, would you consider selling me your old genuine clutch springs please?

3
General / Re: what did you do with your fazer today ?
« on: 11 September 2016, 08:45:54 pm »
I doubt any manufacturer uses release agent any more, perhaps this will help explain it,


Bridgestone's official line is they dont use release agent and accidents are due slow speeds conering where there there is less load on the tyre so the trye not being forced into the tarmac, couple that with brand new smooth tyres = recipe for disaster, there is a thread on here from bridgestone about tyres from way back in 2010 but for some reason when I copy and paste it doesnt show up.



4
FZS600 Fazer / Re: Clutch draggin when hot
« on: 06 September 2016, 07:01:11 pm »
have you thought that the oil itself might be shaggged, oil gets hot and gets thinner-if its old it might not be lubricating like the bike was designed for.
£28.50 for oil and filter-decent brand name, maybe time for a oil change, although a pig to get the oil filter off without the right tools

5
FZS600 Fazer / Re: Rattle/vibration noise
« on: 22 August 2016, 08:06:41 pm »
are those carb rubbers ok? frankly they don't look there best and if your sucking more air than you should be that might be exasberating your problem, i'm not a mechanic but just a thought.

6
FZS600 Fazer / Re: Good, sticky grips?
« on: 20 August 2016, 02:11:33 pm »
is grips the real problem? you could buy better gloves and not have that problem-just a thought :D

7
FZS600 Fazer / Re: Mirror vibration
« on: 05 August 2016, 06:11:09 pm »
Darrsi


you had them mirrors come through yet?

8
FZS600 Fazer / Re: Mirror vibration
« on: 03 August 2016, 06:12:09 pm »
if I were you i'd be checking to see if the mirrors have the rubber support between the fairing and the fairing brackets, also you could get the front wheel rebalanced and check the front wheel bearings, other than that I wouldn't have the foggiest idea, best of luck

9
FZS600 Fazer / Re: Crap mirrors on '98
« on: 30 July 2016, 08:24:18 pm »
there from Guernsey


i'm also not keen on the genuine foxeye mirrors sticking out above the screen, now these are not genuine and there a slightly different shape to the originals, much sqaure'er just like the boxeye headlights, i'm proper happy with mine,

now just clear indicator lenses and black handle bars and it'l be almost perfect

10
FZS600 Fazer / Re: Crap mirrors on '98
« on: 30 July 2016, 07:32:45 pm »
they wont reply to your offer now, they dont work weekends, reply will come through early monday morning

11
FZS600 Fazer / Re: Crap mirrors on '98
« on: 30 July 2016, 02:06:55 pm »
I have just bought some from ebay 152130239199 they were up for £14.50 buy it now or best offer, I offered £10 and got myself a pair of brand new mirrors delivered fast and fit perfect, they are about 50mm wider than the original boxeye mirrors, and they don't 'stick up' like the foxeye mirrors do, pictures should help you. i'm well chuffed with mine :lol

12
FZS600 Fazer / Re: Another HeadLight Post
« on: 16 July 2016, 09:33:06 pm »
to be honest i hadnt actually noticed the fog light part, i was utterlly intrigued that theres projector h4 bulbs out there, might be an easyer headlight upgrade was my thoughts, as Darrsi pointed out to me tho is that i would still need to make a 2nd h4 slot as currently only 1 headlight is h4

13
FZS600 Fazer / Re: Show me your fazer!
« on: 16 July 2016, 09:29:04 pm »
nice picture SIDEWINDER, i see your using the later model mirrors, these dont seem any wider to me so my question is have they improved the viewing angle from behind? from what ive seen it looks to me that although the mirrors have longer stems this extra width isthen taken away due to the mirrors pointing upwards more than the originals, are they much better?

14
FZS600 Fazer / Re: 1999 600 shock upgrade
« on: 12 July 2016, 06:17:52 pm »
For the front I recommend 20 weight oil as this makes the front rather stiff, then wind the rear shock up on its tightest setting, mines a 1999 and is just perfect for me, a little on the stiff side just the way I like it.😃

15
could it be low on engine oil? while that may sound daft-my brother couldnt get his car to start and that was cranking and cranking, turned out theres a safety device on the oil level so when low it wont start to stop you doing damage to the engine, just my 2 pence worth. hope you solve it


kill switch been accidently flicked on?
side stand switch not returning properly?

16
Introduction / Re: general information please
« on: 10 July 2016, 08:40:04 am »


Yamaha FZS600 for sale
A2 Restricted.
LennyFZ has this for sale on here in the fzs600 section :)


12 months MOT
35800 miles
New front tyre, near new rear.
Some cosmetic damage, as shown in pictures.
Comes with a Delkevic 350mm oval exhaust, near new. As well as original. Also a Haynes manual.
Looking for £1000 Ono.
More pictures available on request


17
FZS600 Fazer / Re: Another HeadLight Post
« on: 08 July 2016, 07:48:30 pm »
which of these would be the better headlight mod, there both HID projectors but with 1 kit you dont need to take the headlight apart to fit, anyone tried this method? and did it work well? all feed back much appreciated, sorry if i hi-jacked a post but I thought some might be screaming with yet another headlight post, thanks in advance


method 1


method 2


18
FZS600 Fazer / Re: Show me your fazer!
« on: 05 July 2016, 07:07:19 pm »
heres mine

19
For Sale & Wanted / Re: WANTED Genuine yamaha fzs600 clutch springs
« on: 02 July 2016, 01:20:59 pm »
bump

20
General / Re: EU!
« on: 01 July 2016, 08:11:25 pm »
so guys, who do think will be the next conservative PM?


my opinion would be Michael Gove :eek
[/size][/color]
[/size]I liked[/color]
[/size]The Vote Leave campaign, masterminded by Gove, had pledged an extra £350m a week for the NHS. Gove also said he would end free movement, introduce an Australian-style points-based system for immigration and bring numbers down[/color] :lol
[/size][/color]
[/size] dont like[/color]
[/size]waiting till 2017 till we start the 2 year process[/color]
[/size][/color]
[/size]your thoughts?????[/color]

21
FZS600 Fazer / Re: Crap mirrors on '98
« on: 29 June 2016, 05:44:32 pm »
i have the very same issue that is i cant see behind me when riding etc, angled extension brackets off of the fairing would be great, havent yet seen any about and havent figured out how to make some nice ones, your not on your own

22
For Sale & Wanted / WANTED Genuine yamaha fzs600 clutch springs
« on: 26 June 2016, 11:06:32 am »
Anyone got any fzs600 clutch springs for sale? They must be genuine yamaha not aftermarket ebc etc, thanks, mine is a 1999 boxeye model

23
FZS600 Fazer / Re: clutch is heavy FZS600 1999
« on: 25 June 2016, 08:07:32 pm »
Mine looks the same as that picture, moves very smoothly but is stiff even without the cable attatched and off the bike

24
FZS600 Fazer / Re: clutch is heavy FZS600 1999
« on: 25 June 2016, 06:02:35 pm »
New clutch cable finally arrived today, ive fitted it an regreased the bearings in the left hand clutch housing, it seems the clutch housing is my issue as the spring is really strong, niw do yamaha do a softer spring for the left hand cable housing? Would it work if i stretched the spring in there thus requiring less force to pull the lever in with?
Thanks

25
General / Re: what did you do with your fazer today ?
« on: 21 June 2016, 08:14:36 pm »
W O W
Fitted a mode button on rh handlebar to change view mode multi guage on my fazer 1000[/size]https://goo.gl/photos/FAqWsNm5jVhdLGWd7Sent from my HUAWEI GRA-L09 using Tapatalk 2


now thats the cooolest thing ive ever seen on a fzs600, like it-like it alot :lol , wish I could afford one of them

Pages: [1] 2 3