Fazer Owners Club - Unofficial

Bikes, Hints'n'Tips => Fazer 1000/FZ1 corner => Topic started by: Dave1000 on 27 September 2020, 03:52:26 pm

Title: Fazer 1000 exup
Post by: Dave1000 on 27 September 2020, 03:52:26 pm

Help took off exup valve and the bush is solid in the exup casing tryed taping it but won't budge any ideas  :rollin thanks !!

Title: Re: Fazer 1000 exup
Post by: Falcon 269 on 28 September 2020, 07:27:52 am

Hi and welcome. :)

Which bush is stuck?  The one inside the EXUP housing at the far end of the valve, or the bush that fits in the EXUP cover?

In either case, provided that the valve spindle rotates freely in the bush without excessive freeplay, it's not matter for concern.  Just slather it in copper grease when you reassemble it and call it good.

Title: Re: Fazer 1000 exup
Post by: teecee90 on 29 September 2020, 04:15:10 pm

If the bush needs replacing (as mine did), lots of heat is required. I used a mapp gas blow torch.