26
FZS600 Fazer / Re: Yamaha fazer fzs 600 cuts out when clutch lever is released.
« on: 25 February 2021, 11:34:25 am »Is your clutch cable adjusted properly at both ends?if its wasnt correctly set then it would THUD , lurch and stall not just cut out when putting in gear, certainly an electrical issue as its a combo of safety cut out switches not opening/closing a circuit
That's what I would start with.
Thanks everyone i believe the clutch cable is set correctly as i have not had any issues with it in the past, looks like a side stand switch. Ill carry out the checks mentioned before tackling removal.
He's not actually mentioned if any of this is happening or not though.
Gotta start with the obvious and easiest things first, so if it's clutch related then you must have the clutch cable set up correctly for starters so that it can be eliminated.
The cable could even be frayed inside as well, and simply need replacing.
By the way, i notice nobody has mentioned what a nightmare the sidestand switch is to replace, and it's in a horrible position to get access to, so take that into consideration as it is not a straightforward swap at all. Just thought i'd give a heads up on that one.
Quick update, finally nailed the fault it was an intermittent connection on the pick up coil plug. As the side stand plug and neutral plug are located in the same place as the pick up plug i must have pulled one of the wire and so it became intermittent when trying to run. Still unsure as to why it caused me to have to pull the clutch lever in to start but it RUNS!!
Thanks again everyone for all your help.