When checking my Exup for the first time the other day I was dismayed to find it's in quite a bad state. Only one of the 3 bolts holding on the cover was still there, other 2 broken off in the casing by the previous owner of the bike, it gets better, the two allen bolts that hold the actual Exup valve in the exhaust body are completely rounded off inside and so badly corroded I seriously think they will snap if I try and get them out. If that wasn't bad enough, I also noticed a significant amount of slack in both cables, so after spraying the pulley and cables with enough wd40 to cook an egg I decided to adjust the cables to take out this slack. More trouble followed, both the cables had obviously never been adjusted and were quite tight,a bit more wd40 I thought. I managed to slacken one off without too many swear words but the other alas no. As I began to adjust the cable the bloody thread on the adjuster snapped off inside the adjuster itself. As Mr Hugh Grant would say "bugger bugger bugger". I therefore have to replace the Exup cables now and I nearly had a heart attack when I saw the price. I did find a cheaper alternative on Flea Bay but I dont know much about them, are they worth a gamble ?
Any advice or help greatly appreciated