Date: 12-04-21  Time: 06:57 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cojonesdeloro

Pages: [1]
1
FZS600 Fazer / Re: None starter
« on: 19 October 2020, 04:13:02 PM »
Thanks again for suggestions lads, I bought a 15ltr ultrasonic cleaner and the carbs got stripped then have been in for several cleanings (they are mint now) the main problem was the carb icing circuit, the water lines were solid with gunge, took hrs of fettling but they are now clean. I have some strange wiring from the battery that I think may have been an alarm or immobiliser in the past ( extra fuse holder) I'm wondering if this could be at fault also. still looking. have also ordered a compression testing kit, what sort of pressure should I be looking for? not beat yet  8) cheers. Daz.

2
FZS600 Fazer / Re: None starter
« on: 17 October 2020, 06:18:44 PM »
Almost listed it on the bay today but had a look at the TPC after watching a YT vid, I can set it to 5000rpm but soon as I crank it over and check again its back to 10k, dies this tell us anything lads? P.S float bowls are full and I smell fuel at the pipe, plugs are wet just didnt look obviouse as they are still shiney. 👍

3
FZS600 Fazer / Re: None starter
« on: 12 October 2020, 09:52:36 PM »
Plugs seem dry. 👍

4
FZS600 Fazer / Re: None starter
« on: 12 October 2020, 06:50:13 PM »
So tonight  I put fuel in each pot, nothing, not even a fart, double checked for spark and its as fat as ya like, also checked coil conections and all is correct front and back. My boss is lending me his compression tester 2moz but I am fearing the worse for this F lads🤕🤕

5
FZS600 Fazer / Re: None starter
« on: 12 October 2020, 09:37:54 AM »
Some good suggestions here lads🙂👍 Ill do a compressiin check and check the coil conections, the last owner fitted a new coil so checking tge backs was something I didnt look at. Ill report back.😎👍

6
FZS600 Fazer / Re: None starter
« on: 11 October 2020, 07:30:23 PM »
Cheers lads, yea looked in to the ht order 2day, all is as standard, 1-4 2-3 I hate to let this beat mebut I might just punt this one on😓

7
FZS600 Fazer / Re: None starter
« on: 11 October 2020, 08:22:04 AM »
Thanks lads, yea Im using new fuel, tank is off and Im feedind direct in to the pipe that fits on to the tap, plugs are new and I have a good spark on each pot, ive not tried fuel in to the pots yet, I have a new fuel pump and its working as it should, ignition is working as it should although the key is a bit sticky in the barrel. Its got me stumped, if I have a spark and fuel where is my bang? 🤔🤔

8
FZS600 Fazer / None starter
« on: 10 October 2020, 07:44:42 PM »
Eyup you lot :)
Recently bought another 600 FZS, this is a 99 and was bought as a none runner (stood for 6 years!!!) I have a good spark and have stripped and ultra sonic cleaned the carbs, new plugs and air filter, it turns over strong but wont fire. Any ideas guys?

9
I'd encourage you to check out the FAQ at the top of the main page, it sounds like your bike is a US import and the FAQ will help you confirm this as well as giving you a lot more useful information. As far as I am aware the OEM silencer should be the same fit for all GEN1 bikes but I can't see why you would want to fit a heavier more restricted system unless you're in a country that requires OEM kit to pass an annual inspection.


I did check the FAQ but couldn't find anything re standard systems. I understand what you mean bud but I just don't like noisy cans, It has a Fuel can fitted that isn't too bad but on long trips I find them anoying.


Cheers.
Daz.

10
The headlight switch was removed from the UK/EU market Gen 1 in 2003 or thereabouts so that's normal and doesn't indicate yours might be a US import. :)

The 2005 year stock silencer has 3 tubes inside the link pipe which are part of the token catcon fitted to the final year Fazers.  Makes no difference to fit or performance if you happen to get one for your bike.


Thanks for the info bud, It is a UK bike I have so just wanted to check it wasn't a mod or something strange.


Cheers.
Daz.

11
Hi all,


Just took delivery of an 05 FZS1000S,


I'm looking at going back to a standard can, I have found some on EBay, just wondered if they are all the same system from 01-05?


Also my right hand switch gear has a blank where I would normally find a switch for side/main beam etc, the lights are hard wired to be on all the time, is this standard?


Please excuse the newbie questions, and thanks in advance for any advice.


Cheers.
Daz.


Whereabouts in the country are you Daz? Ive got two standard cans in my garage You're welcome to one of them FOC if you can collect? I really would rather not bother packing it up to post it. I'm based in RG8 0AJ area   


Cheers for the offer bud, I'm in gods own country (South Yorkshire) so you are a bit out of my way, thanks anyway, very good of you to offer.


Daz.

12
Fazer 1000/FZ1 corner / Just got my first FZS1000 couple of questions
« on: 03 January 2018, 09:51:34 PM »
Hi all,


Just took delivery of an 05 FZS1000S,


I'm looking at going back to a standard can, I have found some on EBay, just wondered if they are all the same system from 01-05?


Also my right hand switch gear has a blank where I would normally find a switch for side/main beam etc, the lights are hard wired to be on all the time, is this standard?


Please excuse the newbie questions, and thanks in advance for any advice.


Cheers.
Daz.

13
Introduction / Back in Black...well Black and red ;-)
« on: 30 December 2017, 06:23:06 PM »
Eyup you Foc'ers :)


Just re activated my account after 10 years :eek [size=78%], had a 2001 600 new back in the day, I've had all sorts since and even had a couple of older Honda projects featured in Practical Sports Bikes Mag,[/size]


had a very long lay off bikes due to work and other life stuff, long story short turned 47 this year so though I better get back in the saddle, have just bought a 2005 thou, have some unfinished business with bikes so have jumped back in with the Fazer, I always wanted one ever since they came out, I loved my 6 and hope to get the same ride but with more cubes :-)


Anyway, looking forward to looking round the site and seeing what you lads have been up to, just wanted to say hi.


All the best.
Daz.

Pages: [1]