Hi Guys n' Girls

Just stripped and rebuilt the headstock bearing, still had the original OEM one fitted and had an awful notch at 12oclock. Lovely bikes to work on, was easy to lift old one out, new one in! Was a pleasure to work on.

Any way, i went out for a spin earlier and noticed when the clutch was out and in netural, i could hear a knock, i could also feel it through the seat and frame etc. When the clutch is pulled in that goes away just leaving my slightly noisy cam (getting a manual cct soon)

Any one got any idea of what it might be? Bike is new to me (done about 200miles, bike has 31k) but seems to pull hard, strong clutch, starts on the button and revs crisp.

thanks

Hi guys

Just bought my self, my first Fazer. See picture! I have got this for a few months until summer starts again and i can get another sports bike.
Seems to run fairly well, although has a little CCT rattle.

It also needs a new headstock bearing.
I'm looking to get one and in my experience with bearings it's best to go to a specialist website and get a decent brand which i what i intend to do.


I can see that the upper bearing size is

25x47x15

And lower

30x55x17

I can high quality bearings very easily
Anyone know what seals I would need? It'll be the upper and lower seal so two in total.

If I am unable to find them, I'm going to have to buy one of the pre-made kits, which i would rather avoid doing as they don't normally use as good a' bearings as say SKF.

Thanks for your help