1
FZS600 Fazer / Re: Cam chain rattle question
« on: 11 November 2022, 06:45:00 pm »
did you reset the tensioner to full extension before reinstalling (releasing it all the way back out)
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi there!
Definitely drain the fuel, it'll be stale so get rid of it and dispose properly. I'd also remove the spark plugs and pop a small drop of oil in each cylinder. Then, don't attempt to start on the starter motor, instead turn the engine over manually by putting the bike in a high gear and use the rear wheel to turn the engine slowly through the gearbox. The oil you dropped in will coat the inside of the cylinder as they'll likely be dry right now.
And yeah, new battery
Best of luck
Mike
New pump fitted
New fuel relay fitted
Bike turns over,but petrol is leaking out of the right hand,first carb,over flow,
Any ideas amigos ?
Cheers
🤘🧙♂️🍺🤘
its in the bottom of the tank.exactly what i was gonna say, make sure all the connectors are clean, sometimes even just disconnecting and reconnecting can fix problems.
Lift the tank and make sure the electrical connection is good first. High resistance will show and empty tank.
Is your clutch cable adjusted properly at both ends?if its wasnt correctly set then it would THUD , lurch and stall not just cut out when putting in gear, certainly an electrical issue as its a combo of safety cut out switches not opening/closing a circuit
That's what I would start with.
£4.80 on Wemotoi wondered on the +postage on that and shit myself at £15 postage