Just wired my exup valve fully open...
I got rear ended while at a junction the other day which shunted my exhaust forward crushing the silencer and link pipe. I thought that was more or less the full extent of the damage (the undertray/reg plate were also both broken) and straightened/bashed the pipe (which needed welding as it split at the crease) +silencer back to allow me to use it for my daily commute. It seems that the shunt also bent the headers forward a few inches which snapped both my exup cables so for the last couple of days the bike has been unable to pull up to motorway speeds any faster than a transit van! I can't straighten the headers without removing and looking at the bolts/clamps at the engine side they will likely never go back on, or come off without breaking, we got them bent back a bit but I had to "modify" the center stand bump stop arm to get it to sit on the link pipe stop plate. It has no doubt increased the mass centralisation a bit though...
So, looking around new exup cables are pretty expensive or there are pattern ones for around £35. Anyone used them?
Or is it worth risking second hand ones. I seem to remember someone talking about a rebuild kit from Venhill IIRC but I can't find any for sale.