Date: 24-04-24  Time: 07:33 am

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wthorpy

Pages: [1]
1
General / Re: engine not revving past 6k but only when in gear
« on: 29 July 2015, 06:57:42 pm »
I had the same problem once while on a track day. But mine was due to a small era on my part.
While on track i got a fault on the rev counter to indicate EXUP problem.  So i stripped, cleaned and re fitted, then went back on track. Only to find that it would only rev to about 6k (i think). I returned back to the pits and found that i had put the cables on the wrong way round. ( Schoolboy era.).
Have you/anyone done any work recently.    :)

 Ps. When it was out of gear and on the stand it would rev freely.

2
Fazer 1000 / Re: rev counter gremlin
« on: 25 January 2015, 08:19:05 am »
sid, i agree with Millietant about the stuck EXUP. I've had the same problem and fault code on the rev counter. i just tuck out the EXUP blade, gave it a good clean, re fitted and everything works fine.


After cleaning the EXUP a couple of times, i decided to take the EXUP blade out to see what differences this would make. there was no big dramas, the only issue was while cruising along at low revs and giving it a big handful, it didn't have the low down grunt and pulling power unlike when the blades in.



if you like to ride and change gear above 4000rpm why not take the blade out and you won't need to worry about the EXUP sticking again.

Pages: [1]