Fazer Owners Club - Unofficial

Bikes, Hints'n'Tips => Fazer 1000/FZ1 corner => Topic started by: gnm on 15 August 2015, 09:19:55 am

Title: gen 1 rough running at 6000 rpm
Post by: gnm on 15 August 2015, 09:19:55 am

any ideas what its likely to be?  runs fine up to approx 6000 then just starts to misfire, let throttle  off slightly and it goes fine. sometimes runs fine but theres no telling when its going to do it. replaced exup cables, cleaned and lubed valve about 2000 miles ago after 7000 message on tacho.

Title: Re: gen 1 rough running at 6000 rpm
Post by: Falcon 269 on 15 August 2015, 10:42:33 am

Start by checking that nothing is obstructing the air intake and then report back. :)

Title: Re: gen 1 rough running at 6000 rpm
Post by: gnm on 15 August 2015, 01:06:07 pm

thanks, found the problem. the 7000 fault came up again this morning so took the cover off to check valve working ok and found one of the new cable liners had slid down the inner cable and melted itself round the pulley. back to normal now thanks again for your reply.

Title: Re: gen 1 rough running at 6000 rpm
Post by: Falcon 269 on 15 August 2015, 03:20:02 pm

Good, thanks for the feedback.