1
FZS600 Fazer / "New" Fazer - already in for a fettle! Advice needed.
« on: 24 February 2014, 10:02:25 pm »
So after running around on Thundercats and then SV650's for a while, I picked up a '01 FZS600 here in Cardiff, and if I'm honest, compared to my last couple of bikes (sheds) this one's been treated right, and I'm looking to keep her that way! Aside from a blow on the downpipes and a squared off rear, she's been looked after and generally rides rather nicely.
http://imgur.com/iVoazeG
First thing was adjust the clutch, which I was pretty used to off the Thundercat - screw was a bit tight to start with, but seems miles better now if not still a little snatchy. At the same time, I thought I'd check behind the sprocket cover and look at the front sprocket nut that everyone was talking about.
I'm guessing this is the 9mil nut that's the bane of all fzs owner's existence, though thought I'd throw it on here first for confirmation. Seems solid at the moment, however if recommended would certainly look at changing - what say ye?
The second thing I looked at was more commuting-based, as whilst I don't like the weight or bulk of engine bars, a daily run into and out of Central Cardiff would be tempting fate without them - as such, scored a set of Genuine yamaha jobbies - however they've arrived without the fittings being a secondhand purchase - what am I going to need bolt-wise to get them on?
Believe it's exactly the same set as these here if it's any help! http://kleinanzeigen.ebay.de/anzeigen/s-anzeige/original-fzs600-sturzbuegel-5dm-w0741-00-neu-ovp/173493263-222-4719
Next jobs include an imminent K&N, looking at some SS downpipes, and the headlight mod, as well as a new set of PR 3's. The two points above (crash bars especially) are more urgent however, so any advice is much appreciated.
http://imgur.com/iVoazeG
First thing was adjust the clutch, which I was pretty used to off the Thundercat - screw was a bit tight to start with, but seems miles better now if not still a little snatchy. At the same time, I thought I'd check behind the sprocket cover and look at the front sprocket nut that everyone was talking about.
I'm guessing this is the 9mil nut that's the bane of all fzs owner's existence, though thought I'd throw it on here first for confirmation. Seems solid at the moment, however if recommended would certainly look at changing - what say ye?
The second thing I looked at was more commuting-based, as whilst I don't like the weight or bulk of engine bars, a daily run into and out of Central Cardiff would be tempting fate without them - as such, scored a set of Genuine yamaha jobbies - however they've arrived without the fittings being a secondhand purchase - what am I going to need bolt-wise to get them on?
Believe it's exactly the same set as these here if it's any help! http://kleinanzeigen.ebay.de/anzeigen/s-anzeige/original-fzs600-sturzbuegel-5dm-w0741-00-neu-ovp/173493263-222-4719
Next jobs include an imminent K&N, looking at some SS downpipes, and the headlight mod, as well as a new set of PR 3's. The two points above (crash bars especially) are more urgent however, so any advice is much appreciated.