Popped in the garage for a quick 15 min rebuild of my indicator switch after it felt a bit grim and my right indicators were not working (but bulbs fine). After cleaning the switch up, bit of lube etc it felt like new, switch on, left indicators could not be stopped! Strip back down, everything seemed ok. Mess about, try this and that. Notice the hazard switch was on, d'oh! Rebuild it all, all back on. No right indicators, but I notice the rear one flashing rapid. Front bulb fine, no power... Check relay, connections, nothing showing on the volt meter.
Unravel the main white connector block near rectifier. All clean from last time I did it. Try indicators while scratching head, work fine! Traced it down to another broken wire a few inches from the block (dark green). I am starting to think the loom was pulled/yanked when it was crashed before I bought it...
Anywho, a quick 15 mins had turned into an hour and a half - good job er'indoors was out!