Date: 09-05-24  Time: 00:23 am

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Yanto

Pages: [1]
1
If he dont have them i will  :)

2
Fazer 1000/FZ1 corner / Re: FZS 1000 2001 clutch problem
« on: 23 August 2022, 09:15:52 pm »
Its a worn clutch basket its shot just bought a low mileage engine will swap the basket and rebuild the newer engine raise compression etc

3
Fazer 1000/FZ1 corner / Re: Clutch basket
« on: 21 August 2022, 08:57:36 pm »
Thank you my engine has about 70k miles on it but i just bought a 34k engine with  exhaust studs damaged for £120  :lol

4
Fazer 1000/FZ1 corner / Re: FZS 1000 2001 clutch problem
« on: 21 August 2022, 06:51:46 am »
First thing i replaced with oem

5
Fazer 1000/FZ1 corner / Clutch basket
« on: 20 August 2022, 08:42:47 am »
Are there other yamahas that use the same clutch basket etc as i cant find a good one
I want to modify one and not have my bike off the road
Thank you in advance   :D

6
I have refused to fit them for about 10 years because they are known to leak i use genuine only

7
Fazer 1000/FZ1 corner / Re: FZS 1000 2001 clutch problem
« on: 18 August 2022, 06:07:35 pm »
No its a strange one i am tightening and slackening the cable all the time
I was doing a hill start the othere day then pulled the clutch it would not dissingage tightend the cable it was fine then 2 miles down the road clutch was slipping had to slacken the cable again

8
Fazer 1000/FZ1 corner / Re: FZS 1000 2001 clutch problem
« on: 17 August 2022, 05:53:50 pm »
did you find the fault as i have this problem and its not the cable ?

9
Introduction / Re: new member in wales
« on: 18 February 2022, 03:21:46 pm »
not for me sometimes i like to take it easy :)

10
Introduction / Re: new member in wales
« on: 30 December 2021, 07:10:18 pm »
MUAR .?
went out with them once my mate rides with them

11
Fazer 1000/FZ1 corner / Re: Rear shock ? ....sorry!
« on: 30 December 2021, 07:08:14 pm »
yes the shock


12
Fazer 1000/FZ1 corner / Re: Rear shock ? ....sorry!
« on: 26 December 2021, 12:42:17 pm »
i am doing up a neglected 03 and doing suspension now i got the 08 r6 shock
drilled the top to 12mm got 2mm spacers for the top
found a very helpful guy on ebay that has all dogbone size
if you want standard hight its 130mm i wanted to lower mine so got 134mm so just under 20mm lower

13
Introduction / Re: new member in wales
« on: 20 November 2021, 05:28:43 pm »
Well, hello there.
Where abouts are you based? I'm down south near Newport.
carmarthen but hope to be moving down pontypridd way

14
Introduction / new member in wales
« on: 13 November 2021, 10:04:03 pm »
hi bought a fazer 1000 with dream machine paint
always had kawasaki but wow better then my z1000

Pages: [1]