Date: 18-12-18  Time: 10:43 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - baldy

Pages: [1]
1
For Sale & Wanted / wanted
« on: 23 September 2017, 10:54:15 PM »
Hi Foccers,I'm after a left hand/nearside mirror and a rear sprocket carrier preferably with a good standard sprocket and cush drives,if you have any or all.the bike is a 2000 mk 1 600 fazer.
                             A thousand thanks,Ian

2
General / back again
« on: 02 March 2017, 09:43:53 PM »
ey up,I sold my fazer 1000 a couple of years ago,couldn't leave it alone and have just bought a 600 quite by accident.I'll be posting my old 1000 spares once I've sorted them out and look forward to many hours buffoonery on me 600,regards,Ian

3
Fazer 1000/FZ1 corner / arses
« on: 16 March 2015, 08:48:39 PM »
hello chaps,I've  had the dredded exup fault show up on my bike[gen 1 fazer 1000]after stripping and copper slipping the valve I found a frayed exup cable.i've replaced  the cables with genuine new ones and now the bike feels underpowered and the fault has displayed once more and then not reappeared again.any ideas where I've foced up?any suggestions welcome,i'm at the point of throwing the towel in with this bike.its great apart from the constant exup problems. :'(

4
Fazer 1000/FZ1 corner / daft question of the day
« on: 17 February 2015, 08:17:22 PM »
can anyone tell me how to adjust the clock{time}on my gen 1 fazer thou? it'll give me something to do after I've striped the exup valve a bloody gain!

5
Fazer 1000/FZ1 corner / drive chain
« on: 10 July 2013, 09:40:16 PM »
What do you blokes use to clean your drive chains with?,can you use paraffin or does it knacker o rings up?these and many more questions.baldy.

6
Fazer 1000/FZ1 corner / intermitent exup fault,any ideas?
« on: 05 April 2013, 08:33:48 PM »
Sorry folks,its another exup question.I have a gen1 1000 that has an intermitent exup fault that has started to appear at low revs while trundling through traffic,I stripped the valve and copper slipped everything,ajusted the cables,test rode the bike again and thought i had cured it,riding again in traffic yesterday the fault code on the tacho was displayed ,i turned the ignition off then on again and rode the bike for 30 miles or so and the fault is no longer displayed,the bike is mint has fsh and 33k miles.Any ideas?

7
Fazer 1000/FZ1 corner / side stand awkwardness
« on: 12 December 2012, 02:24:39 AM »
Anybody else find putting the side stand down whilst sat on the bike awkward?I can't get my boot in between the footrest and stand,any useful mods/tips apprieciated as i'm a bit of a shortarse and getting off to flip the stand down will only end up with me pinned under the bugger before long!the bike is a gen 1 fazer1000.thanks

8
Introduction / new fazerist
« on: 04 December 2012, 05:23:46 PM »
Hi folks,got me first fazer,a 2005 1000 off this very site.I pick it up on friday.I've been riding a sorted fj1200 which i hope to keep,garage space permiting.do you meet up,have ride outs etc?This and many other questions,Ian

Pages: [1]