Date: 27-10-20  Time: 03:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Arfurloin

Pages: [1]
1
FZS600 Fazer / Renthal bars
« on: 02 November 2019, 05:56:27 PM »
Hi. Looking to change the bars on my fazer. I know most people fit ultra low 758 Renthal's but, I'm short 5' 7", so think these may bit a bit of a stretch. I believe the 754 Low bars are closer to standard height but wider with less sweep. Does anyone know if they fit without having to extend front brake hose which doesn't look like it has much play on my bike. Thanks.

2
FZS600 Fazer / Cam chain tensioner....... Again
« on: 29 October 2019, 08:19:12 PM »
Hi all. New to this site but have read a good few pages before I joined. As title subject states, I have a 03 fazer with 52,000 miles. Really happy with it for an older bike. Sounds and runs smooth once warmed up. However, the cam chain is rattling on start up but quietens once warm. I've seen on here thats pretty normal behaviour untill adjuster adjusts itself. I'm keen to give it a hand by doing the reset. The comments I've read suggest the adjuster has two springs and a ball bearing. No one mentions two ball bearings which parts manuals show. Can someone confirm. Is it one or two balls. Just like to know before I remove all the bits to get adjuster. Incase I drop something.

3
Introduction / New member
« on: 29 October 2019, 05:22:08 PM »
Hi.
This is Chris. Recently acquired 03 FZS 600. Few issues but I'm working through them. Currently laid up after total knee replacement. Good bit of think and planning time re the fazer.

Pages: [1]