Date: 19-10-20  Time: 16:14 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Muddy Rutter

Pages: [1]
1
For Sale & Wanted / Fazer 1000 Silver 2003 For Sale
« on: 03 August 2013, 08:18:51 AM »
Dear All.


My Fazer 1000 is up for sale on Ebay. Sad to see it go but I rarely have the time to get out on it.


Regards, Nick


[font=.HelveticaNeueUI]http://www.ebay.co.uk/itm/261254339403?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649[/font]

2
Fazer 1000/FZ1 corner / Re: intermitent exup fault,any ideas?
« on: 06 April 2013, 05:22:06 PM »
I read your post with interest as I have been sorting out the EXUP valve on my 2003 1000. Everything was fine when I tested it  last night after a swap out with a used valve from EBay. This morning I pinched all the bolts up and put the cover on. Went off to play in the sun this afternoon and immediately the rev counter was showing the usual 0 - 7k message. Back home I found that the cam retaining bolt was pinching against the cover and stopping the valve moving. Transpires that the cam retaining bolt head  that came with 'new' valve was about 5mm deep against the 3mm or so for the original. Swapped them over and alls well. I also used just one washer instead of the two that came with the valve


One other thought - have you checked and cleaned all the electrical connectors in the servo motor circuit? Hope you get it sorted - good luck. Nick.

Pages: [1]