Date: 28-03-24  Time: 13:43 pm

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Panthor

Pages: [1] 2 3 ... 13
1
General / Re: what did you do with your fazer today ?
« on: 22 April 2019, 02:23:11 pm »
Got stuck 2 hours from with a foccing drill bit in the rear tyre

2
General / Re: The 2018 FOC-U Bike Picture Challenge
« on: 24 February 2019, 10:06:42 pm »
What’s the current challenge?

3
Fazer 1000/FZ1 corner / Re: R1 Front End Bodywork Issues
« on: 14 February 2019, 01:34:10 pm »
Mine rubbed a little bit this was due to the front fairing brackets being slightly bent from a drop. Readjusted then and it’s tight but doesn’t rub now.

4
Fazer 1000/FZ1 corner / Re: TPS question
« on: 24 January 2019, 07:53:52 pm »
Fan always comes on when idling and then goes off when you put it in first gear.
Not sure about the TPS

5
For Sale & Wanted / Re: Gen 1 carbon oval can and link pipe.
« on: 14 June 2018, 08:39:35 pm »
Not quite what I was after but here are the pics for others to see

6
For Sale & Wanted / Re: Gen 1 carbon oval can and link pipe.
« on: 09 June 2018, 07:43:09 am »
pm sent

7
General / Re: The 2018 FOC-U Bike Picture Challenge
« on: 02 June 2018, 08:29:00 am »
Next challenge?

8
Fazer 1000/FZ1 corner / Re: Underseat storage - how big is it?
« on: 28 May 2018, 06:10:20 pm »
I’ve had a 1m chain under mine and the toolkit. Not as much room as the FZS600 I had.

10
General / Re: What Fazer did you spot today?
« on: 17 November 2017, 08:27:26 am »
51 plate blue foxeye 600 with a nice blue flame exhaust @ McDonald's llanelli

11
Fazer 1000/FZ1 corner / Re: Less Is More..........
« on: 18 October 2017, 02:32:34 pm »
This is how my strap looks

12
Fazer 1000/FZ1 corner / Re: Less Is More..........
« on: 18 October 2017, 02:30:34 pm »
I'm actually going to be doing the same to my micron can this week. Looks better shorter to me and like you I want a bit more sound.

Just wondering is that strap fitted correctly? Usually the back would curve round all the way and fit at the same point as the front of it.

13
All received and fitted to my bike, thanks again.
Donation made this morning.

14
Thanks so much, I'll send a donation through to help for heroes

15
Fazer 1000/FZ1 corner / R1 forks torque settings
« on: 02 October 2017, 08:10:53 pm »
Recently bought my thou that has got r1 forks already fitted. I want to take them off to get parts powder coated and was wondering what torque settings would I use when reassembling?

16
For Sale & Wanted / Re: MRA Fazer 1000 gen 1 sports screen. Co. Durham.
« on: 22 September 2017, 08:01:19 am »
I want it but live nowhere near you :(

17
Fazer 1000/FZ1 corner / Re: Led indicators
« on: 08 September 2017, 09:54:35 am »
Also remember you'll need to change the relay to get the correct flash rate.

18
Fazer 1000/FZ1 corner / Re: Led indicators
« on: 08 September 2017, 09:53:42 am »
I personally would buy from Amazon and make sure to check all reviews as like has been said most of the indicators are the same no matter where you buy them just different prices. The last set I bought from a uk supplier of china ones on eBay were coming apart when I had them and I had to clean them up and reseal them.

19
General / Re: who's responsible?
« on: 07 September 2017, 04:03:10 pm »
Is the nail on the inside or outside wall of the tyre? If the outside then yes I would stand my ground arguing that it would have been seen by myself and also the mechanic would have started the conversation stating that there was a nail in the side wall as it does then have to be replaced.
If it's on the inside then I would probably accept that it could have been there previously but I would go and inspect it but not tell them that I was going there (some garages will just make stuff like that up to get you to buy new when you don't need to)

20
For Sale & Wanted / Re: Bits for sale FZS1000 - centre stand, ECU, hugger
« on: 06 September 2017, 04:53:26 pm »
Pm sent

21
For Sale & Wanted / Re: WANTED FZS1000 (gen 1) Center stand
« on: 05 September 2017, 04:17:26 pm »
If you don't use centre stand when out, consider something like an Abba stand.
That's what I did, abba stand is definitely worth it.

22
Fazer 1000/FZ1 corner / Re: Spot the difference
« on: 03 September 2017, 05:36:46 pm »
At least taking it apart and putting it back together gives you the chance to do a thorough clean. 😁

23
Fazer 1000/FZ1 corner / Re: Spot the difference
« on: 02 September 2017, 07:41:55 pm »
Lots, usd forks, front discs, screen, belly pan, exhaust, seat, grips, mirrors. Why? Yours is one of the best looking fazers I've seen

24
Fazer 1000/FZ1 corner / Re: USD front
« on: 02 September 2017, 04:52:29 pm »
Very nice, Fazers always look better with USD in my opinion, wasn't sure on the lights at first but looking at the other pics I do like them and it looks different to other fazers. Good job

25
Fazer 1000/FZ1 corner / Re: Fazer making a noise
« on: 30 August 2017, 01:01:53 pm »
Unfortunately can't blame anyone but myself, I took them off to clean them and didn't put them back on correctly, ah well live and learn

Pages: [1] 2 3 ... 13