This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - robbo
Pages: 1 ... 64 65 [66] 67 68 ... 162
1626
« on: 13 January 2020, 08:58:58 pm »
Wheels out and tyres off this afternoon. Discs off tomorrow, hopefully with no dramas, bearings out, and off to the powder coaters.
1627
« on: 13 January 2020, 05:32:23 pm »
Uncle
1628
« on: 12 January 2020, 07:32:39 pm »
Apache
1629
« on: 12 January 2020, 11:24:30 am »
reservation
1630
« on: 11 January 2020, 07:52:05 pm »
A different president may view the situation differently.
1631
« on: 10 January 2020, 09:57:43 pm »
If the model for the FZ8 instructions are similar to a Gen 1, then other than +ve and -ve, you'll need to identify the crank position sensor lead, and also the speed signal wires coming from the ecu. Using a multimeter and a needle to pierce the insulation, is how I identified the correct leads. If you go for the HealTech GiPro make sure you order the model specific to your bike.
1632
« on: 10 January 2020, 09:42:28 pm »
Have you given him the bill yet?. 
1633
« on: 10 January 2020, 09:40:17 pm »
Spencer
1634
« on: 10 January 2020, 09:25:36 pm »
There's not much I'd rather not be seen on than a C90,maybe a Raleigh Runabout. 
I think a BSA Winged Wheel beats a Raleigh Runabout all day long .
1635
« on: 10 January 2020, 09:19:03 pm »
After years of using an old battery trickle charger and every now and then catching the clips and ripping them off I treated myself to an Oxford Optimiser 888 which comes with a lead and waterproof cap that you connect to the battery and then cable tie to the frame and just plug it in when you need to charge the battery,should have done it yonks ago.
Yep, and it also gives you a useful power outlet. I've got a tyre pump with the same connector.
+1 
1636
« on: 10 January 2020, 05:24:32 pm »
Fazer's back together, finally. Whilst the cam cover was off for the valve clearance check, I had that and the generator cover powder coated. However I forgot to remove the cam chain rubbing block thingy, from inside the cam cover, which melted off in the oven. Been waiting a few weeks for my local Yam dealer to get one in. That was a 22 quid mistake. Up and running this afternoon, so next job is wheels off, and providing the disc bolts come out ok, they'll be off to be powder coated next week.
1637
« on: 10 January 2020, 05:06:28 pm »
I fitted a HealTech to my Gen1. The instructions were quite straight forward, but could be different for your FZ8 though.
1638
« on: 08 January 2020, 09:32:44 pm »
A HealTech SpeedoHealer would sort out the problem, but not cheap at around £85.
1639
« on: 08 January 2020, 07:56:35 pm »
On the news it was mentioned a crowdfunding had been started. If the driver had insurance I'd have thought that would be claimed against, to pay for its rebuilding.
1640
« on: 07 January 2020, 08:58:18 pm »
Ignore the bi-annual info I posted on 10/12/19. I must have deleted the email that I received, giving me that info, and can't find any reference to it on the web.
1641
« on: 06 January 2020, 09:43:44 pm »
. Might be a tad cool for the bucket and spade. I'll save that for the Margate Meltdown. I know roughly what to expect as went to the Weston Super Mare event, many moons ago. If it stays dry, will be a great day out. Get the thou finished and come down.
1642
« on: 06 January 2020, 02:50:46 pm »
Caviar
1643
« on: 06 January 2020, 08:50:12 am »
Nice job Mr.Red. What mileage is on your thou?. Just wondered if this fault is mileage related, or just bad luck. I can see how the Sky Lift would have made life a lot easier for you, that's for sure.
1644
« on: 06 January 2020, 08:34:42 am »
No worries, look forward to it.
1645
« on: 05 January 2020, 05:46:16 am »
A pal of mine is up for this and has got his train ticket sorted.
1646
« on: 04 January 2020, 01:53:29 pm »
Pequod
1647
« on: 01 January 2020, 06:12:39 pm »
A good find unfazed, thanks for posting.
1648
« on: 31 December 2019, 10:03:19 am »
Train ticket sorted . See you at Folkestone. I'll try and get there for 6 to grab a quick coffee.
1649
« on: 30 December 2019, 05:15:31 pm »
1650
« on: 30 December 2019, 01:02:47 pm »
Hypothesis
Pages: 1 ... 64 65 [66] 67 68 ... 162
|
Show Posts
