Date: 29-03-24  Time: 01:23 am

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - uppo

Pages: [1]
1
FZS600 Fazer / Re: Grinding noise/feeling around 6000rpm
« on: 05 February 2019, 10:12:08 pm »
Hi, guys!


Sorry for bringing up this again- FZS 600 vibration at 5.5-6.5k rpm. Has anyone found a solution to this vibration? It is bothering me a lot.

2
For Sale & Wanted / Re: Wanted FZS600 end can (muffler)
« on: 08 August 2018, 03:12:27 pm »
got a scorpion can and link pipe --will get you some pics if interested cheers--


Yes, please! :)

3
For Sale & Wanted / Wanted FZS600 end can (muffler)
« on: 27 July 2018, 05:52:13 pm »
Hi,


looking for a silencer (end can) with link pipe for FZS600 Fazer.  :)

4
FZS600 Fazer / Re: Rev and speedo needles going up and down
« on: 07 September 2017, 11:57:21 am »
Hi!

Old post, but I am facing this problem now.
While I was driving speed and revs "needles" were dropping to zero, then crazy jumping and then again back to zero. This stopped when I turned on turn indicator. I stopped and when tried to turn on motorcycle it was dead (no signs). Previous owner had installed battery main switch (I guess he had faced similar problems as it is installed), I turned it off and on and then everything seemed fine again. I started motorcycle.

Would you suggest me to check contacts and tighter wires on battery? Could it be ECU?

Thanks!

5
Introduction / New Fazer owner
« on: 06 September 2017, 09:15:30 pm »

Hi,


pleasure to introduce myself! Yamaha FZS600 Fazer owner from Riga, Latvia.
Got this great motorcycle in the beginning of summer. As almost every ride makes new questions about the bike, I hope I won't become too annoying!  :)


6
FZS600 Fazer / Sliders, engine guards
« on: 30 August 2017, 07:29:52 pm »
Hi, folks!


I am new here and recently got my Fazer (2002, but with square lights)! I am planning to make by myself (on metal turn lathe) sliders. I am not sure about size (length and width) and place to screw on body. Has anyone experienced this, maybe could share sizes and photo?


Thanks in advance!

Pages: [1]