Date: 28-03-24  Time: 11:28 am

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - castro

Pages: [1]
1
General / speed camera
« on: 06 August 2020, 09:04:08 pm »
Can the new speed cams on the A69 take pic,s of the rear of a motorbike ?. :'(

2
Fazer 1000/FZ1 corner / Re: Mirrors useless gen1
« on: 03 February 2020, 10:00:34 pm »
With extenders from SW,fitted underneath standard mirrors with supplied extension hardware,mirrors still fold and use excisting rubber boots.

3
Fazer 1000/FZ1 corner / Re: high link pipes
« on: 22 June 2015, 08:44:35 pm »
One of these if you can find one ,don't loose anything. :)

4
General / Re: Anyone tried these
« on: 14 January 2015, 07:22:53 pm »
I use them and have had no problems with them.The only issue is they don't extend the mirrors out very far, due to the angle they sit at on the fairing.They do help but I still get a small amount of shoulder in the view.

5
Fazer 1000/FZ1 corner / Re: Finished .
« on: 14 October 2013, 08:16:54 pm »
Well not quite finished ,  special lighter swing arm would be nice,maybe next year ,but would take lots of overtime for that. It is a custom yoke Falcon ,local engineering firm made it to my speck.Its 90 mm deep.It gives me the  range for adjusting the front end height.Forks have KTech 20mm SS cartridges sprung for 100 kl At the moment I,m running 10mm lower than standard.The seat is from Bagster,send em your old seat and they will build to your speck,height,colours,logos,padding ,etc,i was getting bad hip ache,but this is allday comfy with gel pads ,firm, but can still feel whats going on bellow ya.Know what you mean about tank cover but every time I take a picture seems to be after a week away,she will be naked the next time ! :lol .

6
Fazer 1000/FZ1 corner / Finished .
« on: 14 October 2013, 10:36:16 am »
Finished at last ,worth the wait ? ,you bet,phook me does it drop in fast  :)

7
Fazer 1000/FZ1 corner / Re: Fazer Parade - What you got
« on: 22 December 2012, 06:52:05 pm »
This one

Pages: [1]